Question
What is the maximum fixture loading of a 8" pipe sloped at 1%?
Question
Joints for hubless cast iron soil pipe and fittings shall conform to appropriate _____ installation standards.
Question
Color of Steam Division- High Pressure Pipe
Question
Trap arm size of Laundry Tub
Question
Threads per inch for pipe size of 13 mm diameter.
Question
A pressure regulator must be installed if the local water service pressure is above ____
Question
The public sewer may be considered not being available when a sewer is located more than _____ from any proposed building or exterior drainage facility.
Question
A _____ diameter circular basin shall be equivalent to 1 lavatory.
Question
Every building where _____ shall have a sewer service connection to a public or private sewer systems.
Question
The transference of heat by the upward movement of a warm light air current
WT 2
Score
0 / 10
Correct rate
0%
Correct: 0
Incorrect: 0
Unanswered: 10
Question list
1
What is the maximum fixture loading of a 8" pipe sloped at 1%?2112
2
Joints for hubless cast iron soil pipe and fittings shall conform to appropriate _____ installation standards.IAPMO
3
Color of Steam Division- High Pressure PipeWhite
4
Trap arm size of Laundry Tub38 mm
5
Threads per inch for pipe size of 13 mm diameter.14
6
A pressure regulator must be installed if the local water service pressure is above ____80 psi
7
The public sewer may be considered not being available when a sewer is located more than _____ from any proposed building or exterior drainage facility.61 m
8
A _____ diameter circular basin shall be equivalent to 1 lavatory.457.2 mm
9
Every building where _____ shall have a sewer service connection to a public or private sewer systems.plumbing fixtures are installed
10
The transference of heat by the upward movement of a warm light air currentConvection
11
Copper tubing shall be fully externally protected with a/an _____ and fiberglass wrapping installed inside a split rigid casing whenever installed underground.bitumastic coating
12
Which installation is allowable for a 6" diameter sewer pipe?For every two meters of run, pipe has elevation difference of 21 mm
13
Linings for showers shall not be nailed or perforated at any point less than _____ above the finished dam or threshold.1"
14
Trap arm size of a service sink51mm
15
The minimum drainage pipe size for sinks, urinals, and dishwasher51 mm
16
What will happen if a drainage piping is placed at slope of 10mm/m due to structural conditions?Decrease in DFU loading
17
What is the water supply connection size for a flushometer tank WC?10 mm
18
A standpipe having a remote control device at each hose stationManually-Operated Standpipe System
19
referred pipe for transporting gasBlack Steel Pipe
20
Thickness of Continuous waste and fixture tailpiece- seamless drawn brassGauge 20 (0.8 mm)
21
Vertical installation of double sanitary tees may be used when the barrel of the fitting is at least _____ larger than the _____ inlet.2 pipe sizes; largest side inlet
22
A fixture allowed to omit a cleanout on a horizontal line less than 1.5 m in length is _____.Bathtub
23
Backflow prevention device for a hose bibbAtmospheric Vacuum Breaker
24
Changes in direction of drainage piping shall be made by the use of approved pipe fittings like the following, except for _____.90 degrees
25
WSFU of a private hose bibb3
26
AVBs of inlets to tanks, vats, sumps shall be installed in the discharge side of the _____ with the critical level not less than _____ above flood level rim.last valve; 152 mm
27
Water pipe joints shall be installed not less than ___ away from sewer line in both directions.3 m
28
Limit stops shall be adjusted to deliver hot water with a maximum temperature of _____.120 °F
29
Clotheswashers in groups of 3 or more shall be rated at _____ each for the common horiontal and vertical waste pipe sizing.6 FU
30
Medical gas piping is most often joined by _____.Silver Brazing
31
A double check valve backflow preventer requires _____ minimum clearance at the bottom for maintenance.305 mm
32
The minimum airgap of a fixture with an effective opening of 25 mm, affected by sidewalls76 mm
33
Voids between pipes and sleeves through concrete floors in the ground shall be appropriately sealed with _____.Bitumen
34
What is the allowed depth of shower dam or threshold?2"-9"
35
1 Laundry Tray must be provided per ____ persons.50
36
All reinforcing webbing shall produce a tensile strength of not less than _____ in either direction.0.9 kg/mm
37
1 Kcal is how many BTU?3.965
38
Each pressure relief valve shall be an approved automatic type with drain and set at a pressure not more than _____.1033 kpa
39
Consists of a body, a checking member, and an atmospheric opening.Atmospheric Vacuum Breaker
40
The discharge capacity of 1 to 1.89 lps corresponds to _____.4 FU
41
A device installed in a drainage system to prevent reverse f lowBackwater Valve
42
Which is not considered a plumbing fixture?Water Heater
43
Hanger rod size for 5" pipe size13 mm
44
Each tailpiece, continuous waste or waste and overflow shall not be less than ___ for sinks, dishwashers, laundry tubs bathtubs, urinals and similar fixtures38 mm. O.D.
45
An additional cleanout shall be provided on a horizontal line with an aggregate offset angle of direction exceeding _____.135°
46
What is the Maximum DFU loading of a 102 mm branch?216
47
Water Closet provision for 300 females in Assembly Places for Public Use11
48
How many fixture units is equivalent to a 30 gpm-rated sump?60 FU