CDG- Plumbing Code 1.2

3回閲覧 • 50問 • 7ヶ月前

問題一覧

The birth of the plumbing profession in the Philippines was traced back to

17th century

Based on the history of plumbing practice" The walled city" known as Intramuros was established as a model community by the?

Spaniards

When was the first approved which inclusion of "asbestos cement pipe" as an approved material.

November 28, 1967

The Filipino plumbers were assigned the task of maintaining, repairing/remodeling plumbing system in all pueblos or town, church and government buildings during?

18th -19th century

Based on the history of plumbing practice, plumbing took a great leap at the turn of the American soldiers, engineers, Thomasite teachers, doctors and evangelist?

20th century

Before Martial Law, Republic Act No. 6541 known as the?

Building Code of the Philippines

Based on the history of plumbing practice, who was the Governor General issued letter of instruction on proper waste disposal when epidemics like cholera, leprosy and other contagious disease engulfed in the Philippines.

General Harrison

The first chief of the Division of the Plumbing Construction and Inspection.

John F. Hiss

Who was the NAMPAP President spearheaded the updating of the RNPCP in 1996?

Jaime M. Cabase

When was the NAMPAP organized and had it registered with the Securities and Exchange Commission.

1935

Known as "Plumbing Law of the Philippines" was signed by President Ramon Magsaysay in June 18, 1955.

R.A 1378

When was the National Plumbing Code of the Philippines promulgated and approved by Malacañang?

January 28, 1959

When was the Board of Examiners for Master Plumber and NAMPAP prepared the Curriculum for Plumbing Engineering and approved by DepED at Feati University?

1966-1969

Plumbing Engineering was first introduced to what School or University?

Feati University

City Ordinance No. 2411 known as the?

Plumbing Code for the City of Manila

Who is the Chairman of Board of Master Plumbers (BOMP) where the NAMPAP submitted the draft code to him in October 1999.

Engr. Fortunato H. Amosco

Who is the Chairman of PRC where adopted RNPCP 1999 which Pres. Joseph Estrada approved last Dec. 21, 1999.

Hermogenes Pobre

RNPC 1999 was approved by Pres. Joseph Estrada last

December 21, 1999

An adequate ____ is one of the most important governances in modern and healthful human existence.

Plumbing Code

How many set of plan shall be submitted of the aforementioned requirements with each application for a permit signed and sealed by RMP.

6 sets

How many set(s) of approved plumbing plan, data and specification will retain by the Administrative Authority.

1 set

How many set(s) of approved plumbing plan, specification and data will retain to applicant and owner?

2 sets

How many sets) of plan shall be kept or retain to a jobsite at all times while the work is in progress.

1 set

A plumbing permit issued shall expire and become null and void if the plumbing work authorized therein is not commenced within ___ from the date issued.

One year

If the plumbing work is suspended or abandoned at any time after having been commenced for a period of ___.

120 days

In case of renewal of a plumbing permit from the sanction due to expired permit what will be the equivalent fee shall be paid?

½ of original amount

Where shall be a registration number in a round shaped seal placed?

Center below the name.

Where shall be the word "Registered and Licensed Master Plumber" in a round shaped seal placed?

Upper portion of the round.

Where shall be the name of Registered and Licensed Master Plumber in a round shaped seal placed?

Upper center of the round seal

An organization primarily established for purposes of testing to approved standards.

Approved Testing Agency

It includes the Building official, the Commission, the Board where can established and authorize to administer and enforce the provision of R.A 1378.

Administrative Authority

The flow of water or other liquids, mixtures or substances into the distributing pipes of a potable water supply from any source other than from its intended source.

Backflow

Occurs due to an increased reverse pressure above the supply pressure. Ex: pumps, boilers, gravity or other source of pressure.

Backpressure Backflow

The flowing back of used, contaminated or polluted water from a plumbing fixture or vessel into a water supply pipe due to negative pressure in such pipe.

Back-siphonage

Any joint obtained by joining of metal parts which alloys will melts at a temp. higher than 449 degree centigrade but lower than the melting temp of the parts to be joined.

Brazed joint

A group vent pipe which starts in front of the extreme fixture connection on a horizontal branch and connects to the vent stack. (See Loop vent)

Circuit vent

The part of a plumbing system designed and installed to serve more than one appliance, fixture, building or system.

Common

A room or space having a volume less than 1.4 cu.m with 250 kCal of the aggregate input rating of all fuel burning appliances installed in that space.

Confined Space

An impairment of the quality of the potable water which creates an actual hazard to the public through poisoning or spread of disease by sewage, industrial waste also defined as high hazard.

Contamination

A vertical vent that is a continuation of a drain to which the vent connects to the

Continuous vent

A drain connecting the compartments of a set of fixtures to a trap connecting other permitted fixtures to a common trap.

Continuous waste

Marking on a backflow prevention device or a vacuum breaker is a point conforming to approved standards and establish by the testing laboratory.

Critical level

Any connection or arrangement, physical or otherwise, between a potable water supply system and any plumbing fixture which enables non potable, used, unclean, polluted contaminated to enter into any part of a potable water system under any condition.

Cross connection

The liquid or water-borne waste derived from the ordinary living processes, free from industrial waste and of such character that permit satisfactory disposal without special treatment.

Domestice Sewage

A pipe fitting with adjacent reverse bends and shape like the letter "S".

Double bend fitting

Two offsets in successions or in series such that the centerline of the outside ends are in the same straight line.

Double offset

A pipe which carries ground and surface water, storm water or waste water into the building drainage system.

Drain

The water supply pipe between the fixture supply pipe and the water distributing pipe.

Fixtures branch

The drain pipes from the trap of a fixture to the junction of that drain with any other drain pipe.

Fixture drain

A water supply pipe connecting the fixture with the fixture branch.

Fixture supply

YT1 Materials Engineer EXAM

ユーザ名非公開 · 100問 · 7ヶ月前

YT1 Materials Engineer EXAM