Question
A water heater is classified as?
Question
Elastomeric gasketed and rubber-ring joints shall comply with ___________ installation standard
Question
Depth of the molten pig lead in a caulked joint
Question
Copper tubing shall be fully externally protected with a/an _______________ and fiberglass wrapping installed inside a split rigid casing whenever installed underground.
Question
Wiped lead joints shall have an exposed surface on each side of a joint not less than _________.
Question
Copper tube for water supply piping shall have a weight of not less than ________.
Question
Who is the current chairman of the Board of Examiners for Master Plumber?
Question
A plumbing permit shall become null and void if the plumbing work has been suspended or abandoned for a period of ___________.
Question
Code on Sanitation of the Philippines
Question
Common maximum service temperature rating of PVC
Weekly Test 1
Score
0 / 10
Correct rate
0%
Correct: 0
Incorrect: 0
Unanswered: 10
Question list
1
A water heater is classified as?Plumbing Appliance
2
Elastomeric gasketed and rubber-ring joints shall comply with ___________ installation standardIAPMO
3
Depth of the molten pig lead in a caulked joint25.4 mm
4
Copper tubing shall be fully externally protected with a/an _______________ and fiberglass wrapping installed inside a split rigid casing whenever installed underground.bitumastic coating
5
Wiped lead joints shall have an exposed surface on each side of a joint not less than _________.19 mm
6
Copper tube for water supply piping shall have a weight of not less than ________.Type L
7
Who is the current chairman of the Board of Examiners for Master Plumber?Reynald B. Ilagan
8
A plumbing permit shall become null and void if the plumbing work has been suspended or abandoned for a period of ___________.120 days
9
Code on Sanitation of the PhilippinesPD 856
10
Common maximum service temperature rating of PVC140 deg. F
11
Every building where ______________ shall have a sewer service connection to a public or private sewer systems.plumbing fixtures are installed
12
A hose connection with two-gated outlets permitting two connections of the same or smaller coupling diameter to be taken from a single supply line.Wye
13
Each fixture directly connected to the drainage system shall be equipped with a ___________.water-sealed trap
14
For caulked-on closet ring, the minimum overall depth shall be:2”
15
IPS shall be supported at _______ intervals for piping 19 mm diameter and smaller.3 m
16
Preferred when a piece of pipe needed is shorter than 150 cm longDouble Hub
17
(ANSI) Pipe Color code for Fire QuenchingRed with White Lettering
18
The Plumbing Code has been in existence for almost __________ since its promulgation before it has been amended40 years
19
The year when NAMPAP was organized and registered with the Securities and Exchange Commission1935
20
When was the National Plumbing Code promulgated and approved by the Malacañang?January 28, 1959
21
Tube made of plastic material and colored black. The cross-sectional shape is normally oval and is denoted by its outside diameter or O.D.Polybutylene
22
Integrated within an air accumulator vessel which is designed to discharge a predetermined quantity of water into fixtures for flushing purposesFlushometer Tank
23
Distance of bottom of all pipe tranches to the footing of any adjacent building or structure parallel to it45 degrees
24
The birth of the plumbing profession in the Philippines is traced back to the _______ century.17th
25
Trap arm size of Laundry Tub38 mm
26
Date of the Accreditation of NAMPAPOctober 2, 1975
27
In a plumbing unit, how many floor drains are included?3
28
Vertical support of _________ is placed not less than every other storey height.Screwed Pipe
29
The Administrative Authority must be notified at least ___ working days before such inspection is intended.3
30
ASTM means?American Society for Testing and Materials
31
What principle number: No water closet shall be located in a room or compartment which is not properly lighted and ventilated.Principle No. 16
32
1 fixture unit is equal to?1 cu. ft. per minute
33
The distance of water closet or bidet center to center0.75 m
34
Each member of the board, shall at the time of his appointment be at least _____ of age.30 years
35
An open return bend usually made up of two 90° bendsReturn Bend
36
Any change, addition or modification in construction or occupancyAlteration
37
Minimum weight of a lead for flashing or vent terminals14.63 kg per sq.m.
38
A registered master plumber must not supplant another Registered Master Plumber after definite steps have already been taken toward his/her being commissioned to perform the contractCode of Ethics No. 2
39
Color for Type M copper pipeRed
40
What is not included in a plumbing unit?Urinal
41
Voids between pipes and sleeves through concrete floors in the ground shall be appropriately sealed with ________.Bitumen
42
A pipe flange that is not drilled for bolt holes.Blank Flange
43
What will happen if a drainage piping is placed at slope of 10mm/m due to structural conditions?Decrease in DFU loading
44
What section of RA 1378 enumerates the qualification for persons applying for examination?Section 12
45
What is the accreditation number of NAMPAP?14
46
All plumbing plans, drawings, diagrams, etc. shall be submitted in ___ sets for permit application.6
47
The top edge of a receptacle from where water overflows.Flood Level Rim
48
A pipe or conduit for carrying sewage and wastewater.Sewer
49
This examination subject in Master Plumbing was originally split into two.Practical Problems
50
An adjustable tubing connection, consisting of a compression nut, a friction ring, and a compression washer, designed to fit a threaded adapter fitting or a standard taper pipe thread.Slip Joint