M7c8

8問 • 1年前

ユーザ名非公開

通報

問題一覧

……..should not subjected to large tensile load

Rivets are designed to be strong in shear and less so in tension therefore

Using a bucking bar which is too light means that the gun

must deliver more blows and may result in premature hardening of the rivet or damage to the skin surface.

When removing a cherryLOCK or cherryMAX rivet,

you should first use a drill the same diameter as the pin, and remove the pin by drilling enough to remove the locking ring, then pinching out the pin with a pin punch.

when using a dipper to gauge the length of a cherry rivet to be used on a riveted joint, the gauge indicates just above (-4).

The length of rivet you should use is 5/16 inch.

the distance between the rivet centre and the edge of the material 2D minimum

Land

Used in places where stress is not particularly high and where flush surfaces are not required often used in longitudinal aircraft skin joints

lap joint

The minimum space between rivets is determined by

the diameter of the rivets being used

The tool is used to cut rivets to size prior to driving

Rivet cutter.

mod5 training

mod5 training

M6c1

M6c1

M6c2

M6c2

M6c3

M6c3

M6c4

M6c4

M6c5

M6c5

M6c6

M6c6

M6c7

M6c7

M6c8

M6c8

M6c9

M6c9

M6c10

M6c10

M6c11

M6c11

M7c1

M7c1

M7c2

M7c2

M7c3

M7c3

M7c4

M7c4

M10c1

M10c1

M7c5

M7c5

問題一覧

……..should not subjected to large tensile load

Rivets are designed to be strong in shear and less so in tension therefore

Using a bucking bar which is too light means that the gun

must deliver more blows and may result in premature hardening of the rivet or damage to the skin surface.

When removing a cherryLOCK or cherryMAX rivet,

you should first use a drill the same diameter as the pin, and remove the pin by drilling enough to remove the locking ring, then pinching out the pin with a pin punch.

when using a dipper to gauge the length of a cherry rivet to be used on a riveted joint, the gauge indicates just above (-4).

The length of rivet you should use is 5/16 inch.

the distance between the rivet centre and the edge of the material 2D minimum

Land

Used in places where stress is not particularly high and where flush surfaces are not required often used in longitudinal aircraft skin joints

lap joint

The minimum space between rivets is determined by

the diameter of the rivets being used

The tool is used to cut rivets to size prior to driving

Rivet cutter.