M7c5

11問 • 1年前

ユーザ名非公開

通報

問題一覧

In first angle projection each view shows what would be seen

by looking on the far side of an adjacent view (opposite upper).

When a large area is shown sectioned the hatching may be limited to

that part of the area which touches adjacent hatched parts or the outline of the large part

The symbol (M) in detail (f) of Figure 5.13, indicates

that the tolerance applies only to the maximum material condition of the dimension or datum feature and may be greater at the actual finished size.

Since 1 June 1956, the Air Transport Association of America (ATA), has used a specification, to:

establish a standard for the presentation of technical data provided by aircraft, engine or component manufacturers.

A limit system is on a shaft basis when the shaft is the constant member and the different fits are obtained by varying the size of the hole

shaft basis

A limit system is on a hole basis when the hole is the constant member and different fits are obtained by varying the size of the shaft

Hole basis

A schematic diagram show

the functional location of components within a system.

If a design amendment is made on a drawing

a new issue number and date must be allocated to the drawing.

Drawing numbers are

unique to each drawing.

Hatching lines are usually drawn at :

60°

An Oblique view is shown face on with the sides and plan projected at an angle of :

45º - 60º.

mod5 training

mod5 training

M6c1

M6c1

M6c2

M6c2

M6c3

M6c3

M6c4

M6c4

M6c5

M6c5

M6c6

M6c6

M6c7

M6c7

M6c8

M6c8

M6c9

M6c9

M6c10

M6c10

M6c11

M6c11

M7c1

M7c1

M7c2

M7c2

M7c3

M7c3

M7c4

M7c4

M10c1

M10c1

問題一覧

In first angle projection each view shows what would be seen

by looking on the far side of an adjacent view (opposite upper).

When a large area is shown sectioned the hatching may be limited to

that part of the area which touches adjacent hatched parts or the outline of the large part

The symbol (M) in detail (f) of Figure 5.13, indicates

that the tolerance applies only to the maximum material condition of the dimension or datum feature and may be greater at the actual finished size.

Since 1 June 1956, the Air Transport Association of America (ATA), has used a specification, to:

establish a standard for the presentation of technical data provided by aircraft, engine or component manufacturers.

A limit system is on a shaft basis when the shaft is the constant member and the different fits are obtained by varying the size of the hole

shaft basis

A limit system is on a hole basis when the hole is the constant member and different fits are obtained by varying the size of the shaft

Hole basis

A schematic diagram show

the functional location of components within a system.

If a design amendment is made on a drawing

a new issue number and date must be allocated to the drawing.

Drawing numbers are

unique to each drawing.

Hatching lines are usually drawn at :

60°

An Oblique view is shown face on with the sides and plan projected at an angle of :

45º - 60º.