M7C19

11問 • 1年前

ユーザ名非公開

通報

問題一覧

Inspection after many of the common abnormal events will be covered in the:

aircraft maintenance manual chapter 5 “Time limits/maintenance checks”

A Hard Landing is one in which the aircraft :

Lands with a high sink rate (or excessive vertical velocity - greater than about 8 feet per second.

there is concern regarding protection from high intensity radiated field (UIRF) as increasing use is made of non-metallic materials in the construction of the aeroplane. This is non-metallic materials:

Reduce the shielding capability against the effects of radiation from external emitters.

The primary function of static discharger wicks is to

Bleed of the static charge that builds up on the aircraft due to friction with air.

A high energy stop resulting in a brake overheat can be caused by a number of situations including a Rejected Take- Off (RTO) or :

emergency landing (overspeed, overweight, thrust reverser failed) or defective brakes (locked on).

Inspection after flight through sever turbulence are similar to inspection after:

Hard landing but without the landing gear inspection.

a lightning strike on an aircraft would be show

The entry and exit points.

Lightning strikes can cause two types of damage

Direct Damage & Indirect Damage .

which of the following is a preventive process against HIRF ?

Visual inspections.

when inspecting an aircraft after a lightning strike , you should observe :

All signs of burning .

When an aircraft has been struck by lightning:

Control surface bearings and hinges should be checked for stiffness.

mod5 training

mod5 training

M6c1

M6c1

M6c2

M6c2

M6c3

M6c3

M6c4

M6c4

M6c5

M6c5

M6c6

M6c6

M6c7

M6c7

M6c8

M6c8

M6c9

M6c9

M6c10

M6c10

M6c11

M6c11

M7c1

M7c1

M7c2

M7c2

M7c3

M7c3

M7c4

M7c4

M10c1

M10c1

M7c5

M7c5

問題一覧

Inspection after many of the common abnormal events will be covered in the:

aircraft maintenance manual chapter 5 “Time limits/maintenance checks”

A Hard Landing is one in which the aircraft :

Lands with a high sink rate (or excessive vertical velocity - greater than about 8 feet per second.

Reduce the shielding capability against the effects of radiation from external emitters.

The primary function of static discharger wicks is to

Bleed of the static charge that builds up on the aircraft due to friction with air.

A high energy stop resulting in a brake overheat can be caused by a number of situations including a Rejected Take- Off (RTO) or :

emergency landing (overspeed, overweight, thrust reverser failed) or defective brakes (locked on).

Inspection after flight through sever turbulence are similar to inspection after:

Hard landing but without the landing gear inspection.

a lightning strike on an aircraft would be show

The entry and exit points.

Lightning strikes can cause two types of damage

Direct Damage & Indirect Damage .

which of the following is a preventive process against HIRF ?

Visual inspections.

when inspecting an aircraft after a lightning strike , you should observe :

All signs of burning .

When an aircraft has been struck by lightning:

Control surface bearings and hinges should be checked for stiffness.