M7c2

11問 • 1年前

ユーザ名非公開

通報

問題一覧

Control of tools is important to good engineering practices. Tools are normally controlled using

either the shadow board or the tool tag systems.

From an aviation point of view, the most important tool check of all is

the final end of work tool check.

CEN is an

European committee for standardization.

Basic size

The theoretical size from which limits of size are derived by the use of tolerances.

Allowance

The minimum clearance space (or maximum interference ) intended between the maximum material conditions of mating parts.

Nominal size

is an approximate dimension that is used for the purpose of general identification

The responsibility for ensuring that any tool used in aircraft maintenance is serviceable and fit for purpose, rests with the

engineer using the tool.

Many of the wide variety of materials, used in workshops, require some form of control in their handling. This control can involve:

Safety, management and economy.

(PAS) means

Publicly available standards

The type of fit that is most suited to the accurate location of mating parts is

transition fit

One of the information included in the calibration records or certificates is

limits of permissible error.

mod5 training

mod5 training

M6c1

M6c1

M6c2

M6c2

M6c3

M6c3

M6c4

M6c4

M6c5

M6c5

M6c6

M6c6

M6c7

M6c7

M6c8

M6c8

M6c9

M6c9

M6c10

M6c10

M6c11

M6c11

M7c1

M7c1

M7c3

M7c3

M7c4

M7c4

M10c1

M10c1

M7c5

M7c5

問題一覧

Control of tools is important to good engineering practices. Tools are normally controlled using

either the shadow board or the tool tag systems.

From an aviation point of view, the most important tool check of all is

the final end of work tool check.

CEN is an

European committee for standardization.

Basic size

The theoretical size from which limits of size are derived by the use of tolerances.

Allowance

The minimum clearance space (or maximum interference ) intended between the maximum material conditions of mating parts.

Nominal size

is an approximate dimension that is used for the purpose of general identification

The responsibility for ensuring that any tool used in aircraft maintenance is serviceable and fit for purpose, rests with the

engineer using the tool.

Many of the wide variety of materials, used in workshops, require some form of control in their handling. This control can involve:

Safety, management and economy.

(PAS) means

Publicly available standards

The type of fit that is most suited to the accurate location of mating parts is

transition fit

One of the information included in the calibration records or certificates is

limits of permissible error.