暗記メーカー

暗記メーカー

​
ログイン
AIRCRAFT FINISHES
15問 • 1年前
  • ユーザ名非公開
    • 通報

    問題一覧

  • 1

    Which of the following is a hazard associated with sanding on fabric covered surfaces during the finishing process?

    Static electricity buildup

  • 2

    What is likely to occur if hydrated wash primer is applied to unpainted aluminum and then about 30 to 40 minutes later a finish topcoat, when the humidity is low?

    A glossy, blush-free finish

  • 3

    Which defect in aircraft finishes may be caused by adverse humidity, drafts, or sudden changes in temperature?

    Blushing

  • 4

    What is used to slow the drying time of some finishes and to prevent blush?

    Retarder

  • 5

    What is the usual cause of runs and sags in aircraft finishes?

    Too much material applied in one coat

  • 6

    Which properly applied finish topcoat is the most durable and chemical resistant?

    Polyurethane

  • 7

    Which type of coating typically includes phosphoric acid as one of its components at the time of application?

    Wash primer

  • 8

    Aluminum-pigment in dope is used primarily to

    Reflect ultraviolet from the fabric

  • 9

    Fungicidal dopes are used in aircraft finishing as the

    First coat to prevent fabric rotting and are applied thin enough to saturate the fabric

  • 10

    Which statement is true regarding paint system compatibility?

    Old wash primer coats may be overcoated directly with epoxy finishes

  • 11

    A correct use for acetone is to

    Remove grease from fabric

  • 12

    Before applying a protective coating to any unpainted clean aluminum, you should

    Avoid touching the surface with bare hands

  • 13

    If registration numbers are to be applied to an aircraft with a letter height of 12 inches, what is the minimum space required for the registration mark N1683C? Note: 2/3 x height = character width 1/6 x height = width for 1 ¼ x 2/3 height = spacing 1/6 x height = stroke or line width

    52 inches

  • 14

    What is likely to occur if unhydrated wash primer is applied to unpainted aluminum and then about 30 to 40 minutes later a finish topcoat, when the humidity is low?

    Corrosion

  • 15

    If masking tape is applied to an aircraft such as for trim spraying, and is left on for several days and/or exposed to heat, it is likely that the tape will

    Cure to the finish and be very difficult to remove

    • airlaw

    airlaw

    ユーザ名非公開 · 119問 · 1年前

    airlaw

    airlaw

    119問 • 1年前
    ユーザ名非公開

    pcar & afcar

    pcar & afcar

    ユーザ名非公開 · 80問 · 1年前

    pcar & afcar

    pcar & afcar

    80問 • 1年前
    ユーザ名非公開

    new set

    new set

    ユーザ名非公開 · 22問 · 1年前

    new set

    new set

    22問 • 1年前
    ユーザ名非公開

    human factor

    human factor

    ユーザ名非公開 · 100問 · 1年前

    human factor

    human factor

    100問 • 1年前
    ユーザ名非公開

    human factor 2

    human factor 2

    ユーザ名非公開 · 29問 · 1年前

    human factor 2

    human factor 2

    29問 • 1年前
    ユーザ名非公開

    Engine instrument system

    Engine instrument system

    ユーザ名非公開 · 54問 · 1年前

    Engine instrument system

    Engine instrument system

    54問 • 1年前
    ユーザ名非公開

    Propellers

    Propellers

    ユーザ名非公開 · 100問 · 1年前

    Propellers

    Propellers

    100問 • 1年前
    ユーザ名非公開

    Propellers (2)

    Propellers (2)

    ユーザ名非公開 · 16問 · 1年前

    Propellers (2)

    Propellers (2)

    16問 • 1年前
    ユーザ名非公開

    Induction and engine airflow system

    Induction and engine airflow system

    ユーザ名非公開 · 42問 · 1年前

    Induction and engine airflow system

    Induction and engine airflow system

    42問 • 1年前
    ユーザ名非公開

    Ignition starting system

    Ignition starting system

    ユーザ名非公開 · 100問 · 1年前

    Ignition starting system

    Ignition starting system

    100問 • 1年前
    ユーザ名非公開

    Ignition starting system (2)

    Ignition starting system (2)

    ユーザ名非公開 · 29問 · 1年前

    Ignition starting system (2)

    Ignition starting system (2)

    29問 • 1年前
    ユーザ名非公開

    Auxiliary power unit

    Auxiliary power unit

    ユーザ名非公開 · 10問 · 1年前

    Auxiliary power unit

    Auxiliary power unit

    10問 • 1年前
    ユーザ名非公開

    Reciprocating engines

    Reciprocating engines

    ユーザ名非公開 · 100問 · 1年前

    Reciprocating engines

    Reciprocating engines

    100問 • 1年前
    ユーザ名非公開

    Turbine engines

    Turbine engines

    ユーザ名非公開 · 100問 · 1年前

    Turbine engines

    Turbine engines

    100問 • 1年前
    ユーザ名非公開

    Turbine engines (2)

    Turbine engines (2)

    ユーザ名非公開 · 20問 · 1年前

    Turbine engines (2)

    Turbine engines (2)

    20問 • 1年前
    ユーザ名非公開

    Fuel metering systems

    Fuel metering systems

    ユーザ名非公開 · 98問 · 1年前

    Fuel metering systems

    Fuel metering systems

    98問 • 1年前
    ユーザ名非公開

    Aircraft landing gear system

    Aircraft landing gear system

    ユーザ名非公開 · 79問 · 1年前

    Aircraft landing gear system

    Aircraft landing gear system

    79問 • 1年前
    ユーザ名非公開

    Sheetmetal & Non sheetmetalic structure

    Sheetmetal & Non sheetmetalic structure

    ユーザ名非公開 · 100問 · 1年前

    Sheetmetal & Non sheetmetalic structure

    Sheetmetal & Non sheetmetalic structure

    100問 • 1年前
    ユーザ名非公開

    Sheetmetal and non sheetmetalic structure

    Sheetmetal and non sheetmetalic structure

    ユーザ名非公開 · 30問 · 1年前

    Sheetmetal and non sheetmetalic structure

    Sheetmetal and non sheetmetalic structure

    30問 • 1年前
    ユーザ名非公開

    Aircraft fuel system

    Aircraft fuel system

    ユーザ名非公開 · 100問 · 1年前

    Aircraft fuel system

    Aircraft fuel system

    100問 • 1年前
    ユーザ名非公開

    問題一覧

  • 1

    Which of the following is a hazard associated with sanding on fabric covered surfaces during the finishing process?

    Static electricity buildup

  • 2

    What is likely to occur if hydrated wash primer is applied to unpainted aluminum and then about 30 to 40 minutes later a finish topcoat, when the humidity is low?

    A glossy, blush-free finish

  • 3

    Which defect in aircraft finishes may be caused by adverse humidity, drafts, or sudden changes in temperature?

    Blushing

  • 4

    What is used to slow the drying time of some finishes and to prevent blush?

    Retarder

  • 5

    What is the usual cause of runs and sags in aircraft finishes?

    Too much material applied in one coat

  • 6

    Which properly applied finish topcoat is the most durable and chemical resistant?

    Polyurethane

  • 7

    Which type of coating typically includes phosphoric acid as one of its components at the time of application?

    Wash primer

  • 8

    Aluminum-pigment in dope is used primarily to

    Reflect ultraviolet from the fabric

  • 9

    Fungicidal dopes are used in aircraft finishing as the

    First coat to prevent fabric rotting and are applied thin enough to saturate the fabric

  • 10

    Which statement is true regarding paint system compatibility?

    Old wash primer coats may be overcoated directly with epoxy finishes

  • 11

    A correct use for acetone is to

    Remove grease from fabric

  • 12

    Before applying a protective coating to any unpainted clean aluminum, you should

    Avoid touching the surface with bare hands

  • 13

    If registration numbers are to be applied to an aircraft with a letter height of 12 inches, what is the minimum space required for the registration mark N1683C? Note: 2/3 x height = character width 1/6 x height = width for 1 ¼ x 2/3 height = spacing 1/6 x height = stroke or line width

    52 inches

  • 14

    What is likely to occur if unhydrated wash primer is applied to unpainted aluminum and then about 30 to 40 minutes later a finish topcoat, when the humidity is low?

    Corrosion

  • 15

    If masking tape is applied to an aircraft such as for trim spraying, and is left on for several days and/or exposed to heat, it is likely that the tape will

    Cure to the finish and be very difficult to remove