Smile Ken Leung (SmileKL)
問題数 20 • 9/28/2023
記憶度
3問
7問
0問
0問
0問
アカウント登録して、解答結果を保存しよう
問題一覧
1
Radio station equipment can be found in:
AN(HK)O Schedule 6
2
A Radio Test Flight Certificate:
Shall be signed by the pilot
3
Radio equipment can be certificate by:
CAD approved person
4
Every exit and internal door during take-off:
Should be free from obstruction, and should not be fastened by locking
5
Slide (or according to AN(HK)O Schedule 5, devices whch will enable a passenger to reach the ground safely in an emergency while the flying machine is on the ground) should be equipped on aircraft:
Public transport with doors higher than 1.83m
6
If the VHF antenna have to be relocated, it would have to be recorded on:
Aircraft log book
7
From where can an aircraft radio station license be issued?
Telecommunication Authority
8
Life jackets solely for use by children under three years of age should be equipped with:
Torch only
9
A change of ownership of an aircraft:
Invalidates the radio license
10
Emergency exit of public transport aircraft with MTWA above 5700kg should be marked with a band not less than 5cm in width:
On the exterior
11
In accordance with the AN(HK)O, aircraft registered in Hong Kong is:
required to carry radio equipment capable of maintaining two way communitcation with the appropriate aeronautical radio stations
12
Aircraft shall not carry any weapons unless it is approved by _______ and is inaccessible to passengers
Chief Executive
13
A change of owner of aircraft, the radio station license becomes:
Invalid
14
Aircraft equipment is specified in :
AN(HK)O Schedule 5
15
Which agencies can issue an aircraft radio station license?
Telecommunication Authority
16
Radio flight test is certified by:
Pilot
17
Megaphone place on aircraft in case of emergency:
is approved equipment
18
The exit marking is required for:
Every public transport aircraft
19
Radio installation of the aircraft:
should be maintained IAW AMS, all aircraft registered (C of A) in Hong Kong in any category
20
The aircraft radio installation must be approved by:
Director of CAD