40 Questions | 暗記メーカー

暗記メーカー

40 Questions

40問 • 7ヶ月前

問題一覧

1

What are the requirements for wearing a helmet?

All motorcycle riders and passengers are required to wear helmets at all times.

2

Grabbing the front brake or jamming down on the rear brake:

Can cause brakes to lock.

3

Passengers on motorcycles should:

Should sit as far forward as possible without crowding you.

4

When riding with a group of motorcyclists, a staggered formation:

Should not be used when entering or exiting a highway.

5

Eye protection:

Should give clear view to either side.

6

A primary cause of single vehicle motorcycle collision is:

Motorcyclists running wide in a curve or turn and colliding with the roadway or a fixed object.

7

The best lane position for a motorcycle:

Can vary depending on road and/or traffic conditions.

8

When riding at night you should:

Reduce your speed because it is harder to see something lying in the road.

9

You should operate the engine cut-off switch and pull in the clutch when:

The throttle is stuck and you can’t free it.

10

To operate a moped you must have at least a _____ license.

Class M2

11

Upshifting or downshifting in a curve:

Should only be done if it can be done smoothly.

12

To avoid confusing other drivers you should:

Make sure your turn signal turns off after you finish a turn.

13

_____ is a major factor in collisions caused by motorcycles.

Following too closely.

14

If your motorcycle starts to wander back and forth while riding over metal bridge gratings you should:

Relax, stay on course and ride straight across.

15

If you must carry a load it should be:

Either over or in front of the rear axle.

16

Grabbing the front brake or jamming down on the rear brake:

Can cause the brakes to lock.

17

What is the best way to stay out of trouble while riding a motorcycle?

To see it coming by looking well ahead.

18

A motorcycle rider has an advantage over an automobile driver when passing parked vehicles because:

A motorcycle rider can avoid the problems of opening doors and people stepping out from between vehicles by driving in the left part of the lane.

19

Brightly colored, reflective helmets and clothing:

Can make motorcycle riders easier to see.

20

To execute a turn safely a motorcycle rider should always:

Lean the motorcycle in the direction of the turn.

21

Vehicle/motorcycle collisions are most common:

At intersections.

22

Following closely to a vehicle in front of you:

Is a factor collisions caused by motorcyclists.

23

In rain or fog, you should:

Reduce speed and use low beam.

24

Your motorcycle side mirrors primarily show:

Part of the lane next to you and most of the lane behind.

25

When carrying loads:

keep the load low and as far forward as possible.

26

Before changing lanes to the left:

Check your left mirror and look to the left.

27

The best way to combat fatigue while riding is to:

Take frequent breaks.

28

A motor-driven cycle is defined as having a motor size of less than:

150 cc

29

When a vehicle attempts to pass you, you should:

Move to the center lane position.

30

To predict how a hazard may affect you, it’s important to:

know the speed, distance and direction that the hazard is moving.

31

To make good judgment in traffic, you need to first:

Search ahead.

32

You are preparing to move to the left lane. To spot vehicles passing beside you, it is best to:

Turn your head to the left.

33

Motorized bicycles or mopeds are NOT allowed to:

Operate on freeways and expressways.

34

The maximum speed at which Class 2 electric bicycles can provide assistance is:

20 mph

35

When preparing for a long ride, you should:

Ensure your motorcycle is in peak operating condition.

36

Convex mirrors on motorcycles make things appear:

Further than they are.

37

To be effective, eye or face shield protection must:

Permit enough room for eyeglasses or sunglasses.

38

If you need to leave the road to handle an emergency, you should:

signal and pull off smoothly.

39

How often should you check the motorcycle’s hydraulic fluid and coolant?

weekly.

40

The main reason riders crash during turns is:

They are going too fast.

MPLE

MPLE

ユーザ名非公開 · 41問 · 13日前

MPLE

MPLE

41問 • 13日前

ユーザ名非公開

Weekly Test 3

Weekly Test 3

ユーザ名非公開 · 50問 · 13日前

Weekly Test 3

Weekly Test 3

50問 • 13日前

ユーザ名非公開

Weekly Test 2

Weekly Test 2

ユーザ名非公開 · 50問 · 13日前

Weekly Test 2

Weekly Test 2

50問 • 13日前

ユーザ名非公開

Weekly Test 1

Weekly Test 1

ユーザ名非公開 · 50問 · 13日前

Weekly Test 1

Weekly Test 1

50問 • 13日前

ユーザ名非公開

Refresher SPDI 1

Refresher SPDI 1

ユーザ名非公開 · 9問 · 13日前

Refresher SPDI 1

Refresher SPDI 1

9問 • 13日前

ユーザ名非公開

Refresher SPDI 1

Refresher SPDI 1

ユーザ名非公開 · 100問 · 13日前

Refresher SPDI 1

Refresher SPDI 1

100問 • 13日前

ユーザ名非公開

Definition of Terms 1

Definition of Terms 1

ユーザ名非公開 · 90問 · 13日前

Definition of Terms 1

Definition of Terms 1

90問 • 13日前

ユーザ名非公開

Standpipe Requirements

Standpipe Requirements

ユーザ名非公開 · 29問 · 13日前

Standpipe Requirements

Standpipe Requirements

29問 • 13日前

ユーザ名非公開

Item 311 Portland Cement Concrete Pavement (PART 2)

Item 311 Portland Cement Concrete Pavement (PART 2)

ユーザ名非公開 · 61問 · 13日前

Item 311 Portland Cement Concrete Pavement (PART 2)

Item 311 Portland Cement Concrete Pavement (PART 2)

61問 • 13日前

ユーザ名非公開

RNPCP Chapter 10 to 13

RNPCP Chapter 10 to 13

ユーザ名非公開 · 93問 · 13日前

RNPCP Chapter 10 to 13

RNPCP Chapter 10 to 13

93問 • 13日前

ユーザ名非公開

RNPCP Chapter 6 to 9

RNPCP Chapter 6 to 9

ユーザ名非公開 · 94問 · 13日前

RNPCP Chapter 6 to 9

RNPCP Chapter 6 to 9

94問 • 13日前

ユーザ名非公開

Practical Problems and Experiences REFRESHER 2

Practical Problems and Experiences REFRESHER 2

ユーザ名非公開 · 70問 · 13日前

Practical Problems and Experiences REFRESHER 2

Practical Problems and Experiences REFRESHER 2

70問 • 13日前

ユーザ名非公開

Practical Problems and Experiences REFRESHER 1

Practical Problems and Experiences REFRESHER 1

ユーザ名非公開 · 100問 · 13日前

Practical Problems and Experiences REFRESHER 1

Practical Problems and Experiences REFRESHER 1

100問 • 13日前

ユーザ名非公開

Sanitation, Plumbing Design, and Installation 3

Sanitation, Plumbing Design, and Installation 3

ユーザ名非公開 · 96問 · 13日前

Sanitation, Plumbing Design, and Installation 3

Sanitation, Plumbing Design, and Installation 3

96問 • 13日前

ユーザ名非公開

Plumbing Code 3

Plumbing Code 3

ユーザ名非公開 · 100問 · 13日前

Plumbing Code 3

Plumbing Code 3

100問 • 13日前

ユーザ名非公開

Plumbing Code 6

Plumbing Code 6

ユーザ名非公開 · 100問 · 13日前

Plumbing Code 6

Plumbing Code 6

100問 • 13日前

ユーザ名非公開

Plumbing Code 5

Plumbing Code 5

ユーザ名非公開 · 100問 · 13日前

Plumbing Code 5

Plumbing Code 5

100問 • 13日前

ユーザ名非公開

Plumbing Code 4

Plumbing Code 4

ユーザ名非公開 · 100問 · 13日前

Plumbing Code 4

Plumbing Code 4

100問 • 13日前

ユーザ名非公開

August 2019 Special PE Exam

August 2019 Special PE Exam

ユーザ名非公開 · 93問 · 13日前

August 2019 Special PE Exam

August 2019 Special PE Exam

93問 • 13日前

ユーザ名非公開

July 2023 PE Refresher

July 2023 PE Refresher

ユーザ名非公開 · 70問 · 13日前

July 2023 PE Refresher

July 2023 PE Refresher

70問 • 13日前

ユーザ名非公開

問題一覧

1

What are the requirements for wearing a helmet?

All motorcycle riders and passengers are required to wear helmets at all times.

2

Grabbing the front brake or jamming down on the rear brake:

Can cause brakes to lock.

3

Passengers on motorcycles should:

Should sit as far forward as possible without crowding you.

4

When riding with a group of motorcyclists, a staggered formation:

Should not be used when entering or exiting a highway.

5

Eye protection:

Should give clear view to either side.

6

A primary cause of single vehicle motorcycle collision is:

Motorcyclists running wide in a curve or turn and colliding with the roadway or a fixed object.

7

The best lane position for a motorcycle:

Can vary depending on road and/or traffic conditions.

8

When riding at night you should:

Reduce your speed because it is harder to see something lying in the road.

9

You should operate the engine cut-off switch and pull in the clutch when:

The throttle is stuck and you can’t free it.

10

To operate a moped you must have at least a _____ license.

Class M2

11

Upshifting or downshifting in a curve:

Should only be done if it can be done smoothly.

12

To avoid confusing other drivers you should:

Make sure your turn signal turns off after you finish a turn.

13

_____ is a major factor in collisions caused by motorcycles.

Following too closely.

14

If your motorcycle starts to wander back and forth while riding over metal bridge gratings you should:

Relax, stay on course and ride straight across.

15

If you must carry a load it should be:

Either over or in front of the rear axle.

16

Grabbing the front brake or jamming down on the rear brake:

Can cause the brakes to lock.

17

What is the best way to stay out of trouble while riding a motorcycle?

To see it coming by looking well ahead.

18

A motorcycle rider has an advantage over an automobile driver when passing parked vehicles because:

A motorcycle rider can avoid the problems of opening doors and people stepping out from between vehicles by driving in the left part of the lane.

19

Brightly colored, reflective helmets and clothing:

Can make motorcycle riders easier to see.

20

To execute a turn safely a motorcycle rider should always:

Lean the motorcycle in the direction of the turn.

21

Vehicle/motorcycle collisions are most common:

At intersections.

22

Following closely to a vehicle in front of you:

Is a factor collisions caused by motorcyclists.

23

In rain or fog, you should:

Reduce speed and use low beam.

24

Your motorcycle side mirrors primarily show:

Part of the lane next to you and most of the lane behind.

25

When carrying loads:

keep the load low and as far forward as possible.

26

Before changing lanes to the left:

Check your left mirror and look to the left.

27

The best way to combat fatigue while riding is to:

Take frequent breaks.

28

A motor-driven cycle is defined as having a motor size of less than:

150 cc

29

When a vehicle attempts to pass you, you should:

Move to the center lane position.

30

To predict how a hazard may affect you, it’s important to:

know the speed, distance and direction that the hazard is moving.

31

To make good judgment in traffic, you need to first:

Search ahead.

32

You are preparing to move to the left lane. To spot vehicles passing beside you, it is best to:

Turn your head to the left.

33

Motorized bicycles or mopeds are NOT allowed to:

Operate on freeways and expressways.

34

The maximum speed at which Class 2 electric bicycles can provide assistance is:

20 mph

35

When preparing for a long ride, you should:

Ensure your motorcycle is in peak operating condition.

36

Convex mirrors on motorcycles make things appear:

Further than they are.

37

To be effective, eye or face shield protection must:

Permit enough room for eyeglasses or sunglasses.

38

If you need to leave the road to handle an emergency, you should:

signal and pull off smoothly.

39

How often should you check the motorcycle’s hydraulic fluid and coolant?

weekly.

40

The main reason riders crash during turns is:

They are going too fast.