TestSkapare

TestSkapare

​
Logga in

c7.7

c7.7
17 frågor • 1 år sedan
  • Aljuboory
    • rapportera

    Frågelista

  • 1

    Bonding

    is the electrical interconnection of all metal parts of an aircraft, provided for the following reasons:

  • 2

    Bonding is the electrical interconnection of all metal parts of an aircraft to:

    Reduces radio

  • 3

    Megger

    Battery Operated device

  • 4

    • Crimping checked for mechanical security by

    pull-off checks

  • 5

    Note: When using conduits drainage holes should exist at low points to relieve moisture caused by condensation

    to allow for drainage of moisture

  • 6

    A requirement has now been formulated to assess the 'resistance to failure' of cables when subjected to a combination

    of insulation damage and fluid contamination.

  • 7

    When using a heat shrink gun; the temperature of the gun should be set to

    100 degree above the heat shrink temperature

  • 8

    The criteria for selection depends on:

    Flexibility required Vibration suffered

  • 9

    The impedance of coaxial cable is

    not affected by the length of the cable

  • 10

    Co-axial cable is preferred to airframe cable in witch application?

    Where the diameter of cable is not important

  • 11

    With a rear release connector the pin will be

    released from the rear and extracted From the rear

  • 12

    Insulation tests should be carried out after circuit installation and where specified in the Maintenance Manual.

    The test should be carried out with a 250 V tester.

  • 13

    The risk of mechanical damage and of damage by fluids or vapors, to cables must be minimized. Where possible, cables are so routed as to avoid such risks; otherwise, adequate protection must be provided for the cables

    above the fluid line

  • 14

    The Display rate of a digital multimeter is

    the number of time per second that the meter takes measurement

  • 15

    Digital multimeter is grouped by the number of counts or digits they display. A 3½-digit meter, for example, can display three full digits ranging from 0 to 9, and one half digit which displays a 1 or is left blank (0). Therefore, a 3½-digit meter displays up to

    1,999 counts of resolution

  • 16

    Tin plated copper maximum continuous temperature is

    260 degrees centigrade

  • 17

    Note: Even when testing very long lengths of coaxial cable, always start the fault finding procedure in

    the shortest pulse width

    • mod 4 test

    mod 4 test

    Aljuboory · 81 frågor · 1 år sedan

    mod 4 test

    mod 4 test

    81 frågor • 1 år sedan
    Aljuboory

    mod 2 test

    mod 2 test

    Aljuboory · 100 frågor · 1 år sedan

    mod 2 test

    mod 2 test

    100 frågor • 1 år sedan
    Aljuboory

    mod 2,2

    mod 2,2

    Aljuboory · 94 frågor · 1 år sedan

    mod 2,2

    mod 2,2

    94 frågor • 1 år sedan
    Aljuboory

    mod 6,1

    mod 6,1

    Aljuboory · 277 frågor · 1 år sedan

    mod 6,1

    mod 6,1

    277 frågor • 1 år sedan
    Aljuboory

    c7.1

    c7.1

    Aljuboory · 18 frågor · 1 år sedan

    c7.1

    c7.1

    18 frågor • 1 år sedan
    Aljuboory

    c7.2

    c7.2

    Aljuboory · 11 frågor · 1 år sedan

    c7.2

    c7.2

    11 frågor • 1 år sedan
    Aljuboory

    c7.3

    c7.3

    Aljuboory · 36 frågor · 1 år sedan

    c7.3

    c7.3

    36 frågor • 1 år sedan
    Aljuboory

    c7,4

    c7,4

    Aljuboory · 20 frågor · 1 år sedan

    c7,4

    c7,4

    20 frågor • 1 år sedan
    Aljuboory

    c7.5

    c7.5

    Aljuboory · 11 frågor · 1 år sedan

    c7.5

    c7.5

    11 frågor • 1 år sedan
    Aljuboory

    c7.8

    c7.8

    Aljuboory · 5 frågor · 1 år sedan

    c7.8

    c7.8

    5 frågor • 1 år sedan
    Aljuboory

    c7.9

    c7.9

    Aljuboory · 8 frågor · 1 år sedan

    c7.9

    c7.9

    8 frågor • 1 år sedan
    Aljuboory

    7.10

    7.10

    Aljuboory · 12 frågor · 1 år sedan

    7.10

    7.10

    12 frågor • 1 år sedan
    Aljuboory

    c7.11

    c7.11

    Aljuboory · 6 frågor · 1 år sedan

    c7.11

    c7.11

    6 frågor • 1 år sedan
    Aljuboory

    c7.12

    c7.12

    Aljuboory · 10 frågor · 1 år sedan

    c7.12

    c7.12

    10 frågor • 1 år sedan
    Aljuboory

    c7.13

    c7.13

    Aljuboory · 10 frågor · 1 år sedan

    c7.13

    c7.13

    10 frågor • 1 år sedan
    Aljuboory

    c7.14

    c7.14

    Aljuboory · 17 frågor · 1 år sedan

    c7.14

    c7.14

    17 frågor • 1 år sedan
    Aljuboory

    c7.15

    c7.15

    Aljuboory · 20 frågor · 1 år sedan

    c7.15

    c7.15

    20 frågor • 1 år sedan
    Aljuboory

    c7.16

    c7.16

    Aljuboory · 14 frågor · 1 år sedan

    c7.16

    c7.16

    14 frågor • 1 år sedan
    Aljuboory

    c7.17

    c7.17

    Aljuboory · 14 frågor · 1 år sedan

    c7.17

    c7.17

    14 frågor • 1 år sedan
    Aljuboory

    c7.18

    c7.18

    Aljuboory · 36 frågor · 1 år sedan

    c7.18

    c7.18

    36 frågor • 1 år sedan
    Aljuboory

    c7.19

    c7.19

    Aljuboory · 11 frågor · 1 år sedan

    c7.19

    c7.19

    11 frågor • 1 år sedan
    Aljuboory

    c7.20

    c7.20

    Aljuboory · 18 frågor · 1 år sedan

    c7.20

    c7.20

    18 frågor • 1 år sedan
    Aljuboory

    Frågelista

  • 1

    Bonding

    is the electrical interconnection of all metal parts of an aircraft, provided for the following reasons:

  • 2

    Bonding is the electrical interconnection of all metal parts of an aircraft to:

    Reduces radio

  • 3

    Megger

    Battery Operated device

  • 4

    • Crimping checked for mechanical security by

    pull-off checks

  • 5

    Note: When using conduits drainage holes should exist at low points to relieve moisture caused by condensation

    to allow for drainage of moisture

  • 6

    A requirement has now been formulated to assess the 'resistance to failure' of cables when subjected to a combination

    of insulation damage and fluid contamination.

  • 7

    When using a heat shrink gun; the temperature of the gun should be set to

    100 degree above the heat shrink temperature

  • 8

    The criteria for selection depends on:

    Flexibility required Vibration suffered

  • 9

    The impedance of coaxial cable is

    not affected by the length of the cable

  • 10

    Co-axial cable is preferred to airframe cable in witch application?

    Where the diameter of cable is not important

  • 11

    With a rear release connector the pin will be

    released from the rear and extracted From the rear

  • 12

    Insulation tests should be carried out after circuit installation and where specified in the Maintenance Manual.

    The test should be carried out with a 250 V tester.

  • 13

    The risk of mechanical damage and of damage by fluids or vapors, to cables must be minimized. Where possible, cables are so routed as to avoid such risks; otherwise, adequate protection must be provided for the cables

    above the fluid line

  • 14

    The Display rate of a digital multimeter is

    the number of time per second that the meter takes measurement

  • 15

    Digital multimeter is grouped by the number of counts or digits they display. A 3½-digit meter, for example, can display three full digits ranging from 0 to 9, and one half digit which displays a 1 or is left blank (0). Therefore, a 3½-digit meter displays up to

    1,999 counts of resolution

  • 16

    Tin plated copper maximum continuous temperature is

    260 degrees centigrade

  • 17

    Note: Even when testing very long lengths of coaxial cable, always start the fault finding procedure in

    the shortest pulse width