Maximum distance for the supports of vertical CISP

Date of the Accreditation of NAMPAP

Minimum weight of a lead for flashing or vent terminals

Who is the current chairman of the Board of Examiners for Master Plumber?

The extension of a soil or waste stack above the highest horizontal drain connected to the stack.

The required thickness of lead bends and lead traps.

A registered master plumber must not supplant another Registered Master Plumber after definite steps have already been taken toward his/her being commissioned to perform the contract

The maximum interval of supports for a 25 mm and larger horizontal screwed pipe.

Copper's outside diameter is always ____ larger than the standard size.

In a plumbing unit, how many floor drains are included?

Which of the following fixture group qualifies the definition of battery of fixtures?

Tunnels shall have a clear height of ___ above the pipe.

What principle number: No water closet shall be located in a room or compartment which is not properly lighted and ventilated.

What is the accreditation number of NAMPAP

This examination subject in Master Plumbing was originally split into two.

A hose connection with two-gated outlets permitting two connections of the same or smaller coupling diameter to be taken from a single supply line.

NFPA __ is inspection, testing, and maintenance of water-based fire protection systems

How much is an installation fee of a plumbing unit?

How many maximum fixtures can be served by a grease trap?

Each member of the board, shall at the time of his appointment be at least _____ of age.

Who shall administer the provisions of RA 1378?

When was the National Plumbing Code promulgated and approved by the Malacañang?

Clean Water Act

How much is an installation fee for water closet, lavatory, sink, bathtub, grease and garage trap.

ECC means?

A plumbing permit shall become null and void if the plumbing work has been suspended or abandoned for a period or _____.

All plumbing plans, drawings, diagrams, etc. shall be submitted in ___ sets for permit application.

Wiped lead joints shall have an exposed surface on each side of a joint not less than _____.

1 fixture unit is equal to?

What section of RA 1378 requires the creation of a Board of Examiners for Master Plumbers after 30 days of the approval of the said Act?

The highest portion of the interior part of any pipe or conduit that is not vertical

The First Amendment to the National Plumbing Code

The top edge of a receptacle from where water overflows.

A valve opened and closed by the fall and rise, respectively, of an attached ball floating on the surface of the liquid.

The Administrative Authority must be notified at least ___ working days before such inspection is intended.

According to the building code, the allowed material for the dry standpipe are _____.

A pipe flange that is not drilled for bolt holes.

The pressure existing without any flow motion

A device located at the bottom of the tank for the purpose of flushing water closet and similar fixtures

water-sealed trap

A physical separation, which may be a low inlet into the indirect waste receptor from the fixture, appliance, or device indirectly connected

A large opening in a sewer line or part of a plumbing system constructed with sufficient size for a man to gain access therein for maintenance purposes

A water heater is classified as?

An adjustable tubing connection, consisting of a compression nut, a friction ring, and a compression washer, designed to fit a threaded adapter fitting or a standard taper pipe thread.

Copper tube for water supply piping shall have a weight of not less than _____.

An open return bend usually made up of two 90° bends

8 psi is equal to _____.

The year when NAMPAP was organized and registered with the Securities and Exchange Commission

ASTM means?

Voids between pipes and sleeves through concrete floors in the ground shall be appropriately sealed with _____.