AIRLAW 2.0

32問 • 1年前

問題一覧

Where would you find the recommended statement for recording the approval or disapproval for return to service of an aircraft after a 100-hour annual inspection?

14 CFR Part 43

Airframe minor repairs includes

Wing and control surface fairings

When can you consider the repair on the following airframe, a major repair

The repair damaged areas in the plywood stressed covering exceeding (6) inches in any direction

Changes to the basic design of the fuel or oil system is considered

Airframe major modification

A permanent record of every maintenance (not including preventive maintenance) repair of building or alteration of any airframe, powerplant, propeller or appliances shall be maintained by

The registered operator

Replacing defective safety wiring or cotter pins is

Preventive maintenance

Where would you find the operating conditions that make a 100 hour inspection mandatory?

14 CFR Part 91

Large airplanes and turbine powered multiengine airplanes operated under Federal Aviation Regulation Part 91, General Operating and Flight Rules, must be inspected

In accordance with an inspection program authorized under Federal Aviation Regulation Part 91, Subpart E

Any repair to spars, ribs, and surface involves

Airframe minor repair techniques

What does it mean it is said that a component conforms with a technical standard order?

It does not require an STC when used in an alteration

The restoration of an engine mounts to a condition for safe operation after damage is classified as

An airframe major repair

Strengthening or reinforcing the fuselage longeron.

Airframe major repair

When a major repair alteration results in any change in the aircraft operating limitations or data contained in approved airplane flight manual appropriate amendments to the aircraft operating limitations shall be made in

The form and manner prescribed by the CAAP

Replacement of components or complete units such as landing gears with parts supplied by the original manufacturer or manufactured in accordance with approved drawings is considered

Airframe minor repair

When an aircraft be operated with a 100-hour inspection overdue?

If necessary to reach a place at which the inspection can be done

A maximum time a 100-hour inspection may be extended is

10 hrs

Which of the following is a portion of the required permanent maintenance record entry after 100-hour inspection?

The date of the inspection and aircraft time in service

Change in the basic design made in accordance with the “ASSEC” of the air transportation approved recommendation of the “Landing gear shock strut” manufacturing or in accordance with ATO airworthiness directives are considered to be

Appliance minor alteration

Removal of accessories that are listed as required equipment on the aircraft or engine specifications is an example of

Powerplant Major Modification

A certification confirming that the maintenance work to which it relates has been complied wit in accordance with the applicable standards of airworthiness using approved data by

Maintenance Release

Separation or disassembly of a crankcase or crankshaft of a reciprocating engine equipped with an integral supercharger is an example of

Powerplant Major Repair

Who is authorized to repair an aircraft instrument?

Certified repair station of the instrument

Who is responsible for maintaining aircraft from unworthy condition?

Licensed Aircraft Maintenance/Mechanic

The restoration of an aircraft/aeronautical product by using methods, techniques, and practices acceptable to the Authority, when it has been disassembled, cleaned, inspected as permitted, repaired as necessary, reassembled, and tested to the same tolerances and limits as a new item, using either new parts or used parts that conform to new part tolerances and limits

Rebuild

Who is responsible for ensuring that all maintenance required to be carried out in the hangar plus any defect rectification carried out during base maintenance, is carried out to specified design and quality standards?

Base Maintenance Manager

The owner of an aircraft or, in the case of a leased aircraft, the lessee, shall be responsible for maintaining the aircraft in an airworthy condition

All of the above

The Contracting State which approved the original type certificate and any subsequent supplemental type certificates for an aircraft, or which approved the design of an aeronautical product or appliance

State of Design

The AMO shall relieve the person performing maintenance functions from all duties for 24 consecutive hour during any

7 Consecutive days

Which part of Philippine Civil aviation Regulation prescribe the requirements for certification of an aircraft and aeronautical components or continuing airworthiness?

PCAR Part 5 (Airworthiness)

Change to the Hub Design is?

Propeller Major Modification

Rewinding the field coil of an electrical accessories is an example of?

Appliance Major Repair

Duration of AMT License is

5 years

Plumbing Tools 2

ユーザ名非公開 · 53問 · 13日前

Plumbing Tools 2