1

10 questions • 2024-05-14
Alexandra Svobodová
Report

Question

A client packet is received by a server. The packet has a destination port number of 143. What service is the client requesting?

  • Telnet

  • IMAP

  • FTP

  • SSH

  • Skip

Question

Which two functions are performed at the MAC sublayer of the OSI Data Link Layer to facilitate Ethernet communication? (Choose two.)

  • implements trailer with frame check sequence for error detection

  • applies delimiting of Ethernet frame fields to synchronize communication between nodes

  • handles communication between upper layer networking software and Ethernet NIC hardware

  • adds Ethernet control information to network protocol data

  • places information in the Ethernet frame that identifies which network layer protocol is being encapsulated by the frame

Question

Which two functions are performed at the MAC sublayer of the OSI Data Link Layer to facilitate Ethernet communication? (Choose two.)

  • enables IPv4 and IPv6 to utilize the same physical medium

  • adds Ethernet control information to network protocol data

  • handles communication between upper layer networking software and Ethernet NIC hardware

  • implements CSMA/CD over legacy shared half-duplex media

  • integrates Layer 2 flows between 10 Gigabit Ethernet over fiber and 1 Gigabit Ethernet over copper

Question

Which two functions are performed at the MAC sublayer of the OSI Data Link Layer to facilitate Ethernet communication? (Choose two.)

  • implements trailer with frame check sequence for error detection

  • adds Ethernet control information to network protocol data

  • implements a process to delimit fields within an Ethernet 2 frame

  • places information in the Ethernet frame that identifies which network layer protocol is being encapsulated by the frame

  • handles communication between upper layer networking software and Ethernet NIC hardware

Question

A new network administrator has been asked to enter a banner message on a Cisco device. What is the fastest way a network administrator could test whether the banner is properly configured?

  • Reboot the device

  • Exit global configuration mode.

  • Enter CTRL-Z at the privileged mode prompt.

  • Exit privileged EXEC mode and press Enter.

  • Power cycle the device

  • Skip

Question

What happens when the transport input ssh command is entered on the switch vty lines?

  • The SSH client on the switch is enabled.

  • Communication between the switch and remote users is encrypted.

  • The switch requires a username/password combination for remote access.

  • The switch requires remote connections via a proprietary client software.

  • Skip

Question

What is the subnet ID associated with the IPv6 address 2001:DA48:FC5:A4:3D1B::1/64?

  • 2001:DA48:FC5:A4::/64

  • 2001::/64

  • 2001:DA48:FC5::A4:/64

  • 2001:DA48::/64

  • Skip

Question

A client is using SLAAC to obtain an IPv6 address for its interface. After an address has been generated and applied to the interface, what must the client do before it can begin to use this IPv6 address?

  • It must send a DHCPv6 REQUEST message to the DHCPv6 server to request permission to use this address.

  • It must send a DHCPv6 INFORMATION-REQUEST message to request the address of the DNS server.

  • It must send an ICMPv6 Router Solicitation message to determine what default gateway it should use.

  • It must send an ICMPv6 Neighbor Solicitation message to ensure that the address is not already in use on the network.

  • Skip

Question

Which range of link-local addresses can be assigned to an IPv6-enabled interface?

  • FF00::/8

  • FDEE::/7

  • FE80::/10

  • FEC0::/10

  • Skip

Question

What mechanism is used by a router to prevent a received IPv4 packet from traveling endlessly on a network?

  • It checks the value of the TTL field and if it is 100, it discards the packet and sends a Destination Unreachable message to the source host.

  • It decrements the value of the TTL field by 1 and if the result is 0, it discards the packet and sends a Time Exceeded message to the source host.

  • It checks the value of the TTL field and if it is 0, it discards the packet and sends a Destination Unreachable message to the source host.

  • It increments the value of the TTL field by 1 and if the result is 100, it discards the packet and sends a Parameter Problem message to the source host.

  • Skip

1

TestMaker

Score

0 / 10

Correct rate

0%

Correct: 0

Incorrect: 0

Unanswered: 10

 
ankimaker.com

Question list

  • 1

    A client packet is received by a server. The packet has a destination port number of 143. What service is the client requesting?

    IMAP

  • 2

    Which two functions are performed at the MAC sublayer of the OSI Data Link Layer to facilitate Ethernet communication? (Choose two.)

    places information in the Ethernet frame that identifies which network layer protocol is being encapsulated by the frame, adds Ethernet control information to network protocol data

  • 3

    Which two functions are performed at the MAC sublayer of the OSI Data Link Layer to facilitate Ethernet communication? (Choose two.)

    adds Ethernet control information to network protocol data, implements CSMA/CD over legacy shared half-duplex media

  • 4

    Which two functions are performed at the MAC sublayer of the OSI Data Link Layer to facilitate Ethernet communication? (Choose two.)

    implements trailer with frame check sequence for error detection, adds Ethernet control information to network protocol data

  • 5

    A new network administrator has been asked to enter a banner message on a Cisco device. What is the fastest way a network administrator could test whether the banner is properly configured?

    Exit privileged EXEC mode and press Enter.

  • 6

    What happens when the transport input ssh command is entered on the switch vty lines?

    Communication between the switch and remote users is encrypted.

  • 7

    What is the subnet ID associated with the IPv6 address 2001:DA48:FC5:A4:3D1B::1/64?

    2001:DA48:FC5:A4::/64

  • 8

    A client is using SLAAC to obtain an IPv6 address for its interface. After an address has been generated and applied to the interface, what must the client do before it can begin to use this IPv6 address?

    It must send an ICMPv6 Neighbor Solicitation message to ensure that the address is not already in use on the network.

  • 9

    Which range of link-local addresses can be assigned to an IPv6-enabled interface?

    FE80::/10

  • 10

    What mechanism is used by a router to prevent a received IPv4 packet from traveling endlessly on a network?

    It decrements the value of the TTL field by 1 and if the result is 0, it discards the packet and sends a Time Exceeded message to the source host.