The distance a wave penetrates into a conductor before being completely absorbed is called

The gate voltage that must be applied to a field effect transistor for it to conduct current is called the

The main problem with the half-wave rectifier is

The two types of transistors are the bipolar and the

The four key components of a wireless transmitter are oscillator, amplifier, antenna and

The frequency of an electromagnetic wave is expressed in units called

The piece of equipment that minimizes the “peaks and valleys” seen in the rectifiers output is the

Another way to smooth the DC output voltage of the rectifier is to add a

The most widely used semiconductor material used in solid state electronic device is

Solid state devices can fail due to

The advantages of transistors over vacuum tubes include size, cost, efficiency, reliability and

There are three key functions of logic circuits, these are to make decisions, preform math and

The component of a DC power supply that convert AC to DC is the:

A passive device that consists of two conductors separated by an insulator is a

What is the approximate built-in voltage,in mV, in silicone diodes

The drawback of a center-tap rectifier is that it requires a

The “dead zone” at the top of an antenna where the antenna does not transmit EM waves is called

The conductivity of a semiconductor can be easily modified through a process called

In a receiver, the information signal is separated from the carrier frequency by the

The binary number system is referred to as a base -__ number system

The four key components of a DC power supply are transformer, rectifier, filter and

A diode only allows current to flow in one direction which makes them useful in

The full wave length rectifier requires a total of _ diodes.

A diode will no longer block current and will start to conduct current when its breakdown voltage is exceeded by the