記憶度
4問
11問
0問
0問
0問
アカウント登録して、解答結果を保存しよう
問題一覧
1
Which of the following regulates the vacuum of the air pump to hold the deicing boots deflated when the pneumatic deicing system is off?
Suction relief valve
2
Why should a chemical rain repellant not be used on a dry windshield?
It will restrict visibility
3
Which of the following connects vacuum to the deicer boots when the system is not in operation, to hold the boots tightly againts the leading edges in flight?
Distributor valve
4
Prior to installation of a pneumatic surface-bonded type deicer boots, on the leading edge of the wing, you should
Remove all paint fron the area to be covered by the deicer boots
5
How do deicer boots help remove ice accumulation?
By breaking up ice formations
6
What are three methods of anti-icing aircraft windshields?
An electric heating element in the windshield , Heated air circulating system, Windshield wipers and anti-icing fluid
7
What is the principle characteristic of a windshield pneumatic rain removal system?
An air blast foarms a barrier that prevents raindrops from striking the windshield surface
8
What is the source pf pressure for inflating deicer boots on reciprocating engine aircraft?
Vane-type pump
9
What controls the inflation sequence in a pneumatic deicer boot system?
Distributor valve
10
What icing condition may occure when there is no visible moisture present?
Carburetor ice
11
Carburetor icing may be eliminated by which of the following methods?
Alcohol spray and heated induction air
12
Which of the following are found in a laminated integral electrically heated windshield system?
Autotransformer, Heat control relay, Heat control toggle switch, Indicating light
13
Two possible sources pf heat for the operation of a wing thermal anti-icing system are
Compressor bleed air and aircraft electrical system
14
What mixture may be used as a deicing dluid to remove frost from an aircraft surface?
Ethylene glycol and isopropyl alcohol
15
What maintains normal windshield temperature control in an electrically heated and windshield sustem?
Thermistors
16
Arcing in an electrically heated windshield panel usually indicates a breakdown in the
Conductive coating
17
What is used as a temperature-sensing elements in an electrically heated windshield?
Thermistors
18
What is the purpose of the oil separator in the pneumatic deicing system?
To protect the deicer boots from oil deterioration
19
What should be used to melt the ice in a turbine engine ifvthe compressor is immobile because of ice?
Hot air
20
Where are the heat sensors located on most aircraft with electrically heated windshields?
Imbedded in the glass
21
Which of the following indications occur during a normal operational check pf a pneumatic deicer system?
Fluctuating readings on the pressure gauge and relatively steady readings on the vacuum gauge
22
Some aircraft are protected against airframe icing by heating the leading edges of the airfoils and intake ducts. When is this type of anti-ice system usually operated during flight?
Whenever icing conditions are first encountered or expected to occur
23
Which of the following is the best means to use when removing wet anow from an aircraft?
A brush or a squeegee
24
What may be used to clean deicer boots?
Soap and water
25
What method is usually employed to control the temperature of an anti-icing system using surface combustion heaters?
Thermo-cycling switches
26
What is the purpose of a distributor valve in a deicing system utilizing deicer boots?
To sequence the deicer boots inflations symmetrically
27
Why are the tubes in deicer boos alternately inflated?
Alternate inflation of deicer boot tubes keeps disturbance of the airflow in a minimum
28
What is one check for proper operation of a pitot/static tube heater after replacement?
Ammeter reading