Which one of the following condition should an OIC of the engineering watch shall not hand over the watch to the relieving officer?

To avoid the possibility of a scavenge fire what important check is to be carried out every watch and more frequently if a damaged piston ring is suspected?

In case of a serious main engine malfuncyion what should be your course of action?

What precaution should be taken when an engineer on duty is inspecting a UMS-mode operated engine room at night

Which of the conditions listed should be immediately reported to the engineering officer on watch?

What is the purpose of oil mist detector?

During regular manned watchkeeping in the engine room how often should the daily service tank be checked?

Which of the following is NOT the initial action to take in case of main engine failure at

What preventive maintenance should be done frequently to diesel engine starting air receivers?

During seven-day period, the minimum standard rest of an officer in charge of the enginnering watch must be

You have just received a call from the watch stander in the engine room reporting that a high temp alarm for a main engine bearing has just sounded. Your next instruction to the watch stander should be to

If you are notified that one of the turbine bearing sis overheated, which of the following action should you take ifrst as the watch engineer?

The ship is underway. The running generator suddenly stopped. What should you for?

When the steering gear is in operation, you hsould

While inspecting the steering gear at sea, you should check for

Which of the following conditoins should be immediatey reported to the engineering officer on watch

While standing watch in the engine room, you notice a high reading at a salinity cell located in the loop seal between two stages of a flash type evaporator. This would indicate

Who is responsible for the isolation, bypassing and adjustment of all machinery under his responsibility that is to be worked on, and is to record all work carried outWho is responsible for the isolation, bypassing and adjustment of all machinery under his responsibility that is to be worked on, and is to record all work carried out

How long are ships required to keep engine room logbook?

In port, the duty engineer finds the refrigeration compressor leaking on the shaft seal. What action should he take?

Why is condensate being pumped from the condenser to the DC heater instead of directly to the boiler?

What is the initial action to be taken in case of scavenge fire?

What is used in turbocharger blower side cleaning of the main engine?

Flame scanners installed on boilers are designed so they

Why does most temperature control valve in diesel engine closed freshwater cooling system bypass the flow of jacket water around the cooler instead of around the engine?

Which action should normally be taken during ech watch when the aux boiler is operating?

While standing watch at the sea, a main engine bearing high temp alarm has just been indicated on the control panel. Your next action should be to

In relieving time, th eoutgoing in charge of the engineering watch should

Who is in charge of the engineering watch at anchorage

You are standing watch in the engine room, with the auxialiary boiler, you should blow down a gauge periodically to

While maneuvering, you discover heavy smoke coming from the turbocharger casing. What action should you take first?

What is the condition of th eboiler water when the pH level approaches zero

Which of the following is the result of loss oof suction of boiler feed water pump?

According to STCW Code Chapter VIII Section A - VIII/1, the administration shall take account of the danger posed by fatigue seafarers, especially those whose duties involve the

Who is responsible for the satisfactory operation and runnng of the engine room while on duty?