問題一覧
1
Specific info on the regulations governing identification and registration marks can be found in
far part 45
2
Compliance with an airworthiness directive may be
All of the above
3
When a mechanic exercises the privileges of an inspection authorization he shall keep it available for inspection for which of the following
all of the above
4
Who is responsible for complying all with airworthiness directives
the aircraft owner
5
How long must temporary records be retained for an executive or Corporate aircraft
until the works is prepared or superseded or after one year
6
An annual inspection must be performed
by a licensed a&p holding an inspection authorization (ia)
7
Which form must an aircraft owner posses in order to operate his aircraft
form 8050-2 aircraft registration
8
As part of annual inspections you should check in the status of pertinent airworthiness directives for the aircraft you are inspecting
the AD listings
9
Filling out an FAA form 8010-4 malfunction or defect report is
voluntary and important to the continued safe operation of general aviation
10
Info on methods of repair of acrobatic might be found in
ac 43.13
11
Which item listed below is not included in the maintenance’ record entry for an aircraft that has received an annual inspection and has been returned to service
a list of discrepancies and unairworthy items
12
Airworthiness directive #2003-19-10 was issued
in September 2003
13
True/False A repairman certificate is no longer effective once the holder is relived from the duties for which the holder was employed and certificated
true
14
Under some circumstances such as private owners operating personal aircraft temporary records are entered in the aircraft powerplant or propeller log books which statement is most correct about these temporary records
all of the above
15
When performing N annual inspection you must use a checklist that at a minimum covers the items specified in
none of the above
16
When an aircraft owner presents evidence that his aircraft conforms to its type certificate and any supplemental type certificates and airworthiness directives the FAA will grant him
form 8100-2 standard aircraft airworthiness certificate
17
Advisory circulars AC 43.13-B change 1 differs from other advisory circulars because
it contains FAA approved data that can be referred when performing repairs
18
You have completed a major alteration on a customer aircraft. What should you do with copies of the 337 form
all of the above
19
A large air carrier is certified under which part of the FAR
part 121
20
Temporary records
must be retained until the work is repeated or superseded by other work
21
When returning an aircraft to service after an inspection which item is not required to be entered in the permanent records
a list of all parts and consumable items used in the inspection
22
The ata spec 100
allows the standardization of maintenance info
23
FAA form 8130-7 special airworthiness certificate is effective
for a limited period of time
24
To find information on your rights privileges and limitations as a certified mechanic you should refer to
Far part 65
25
Compliance with airworthiness directives
is mandatory
26
Illustrated parts catalogs
a&c
27
Which discrepancies discovered on an inspection do not have to be cleared before the aircraft can be returned to service
you may placard items permitted to be inoperative under far part 91.213(d)(2) mark items inoperative and provide the owner a dated list of discrepancies
28
A customer brings you a rare antique aircraft for an inspection the best source of info on this aircraft would be
volume VI aircraft’s listings
29
When providing a description of the work performed in block 8 or form 337 what is the correct method of completing the entry
dare a like after your last entry and print the word end
30
Which of the following is not required to be entered in the permanent aircraft records
amount of oil added to the engine
31
When filling out fork 337 block 8 a description of the work performed must must include
technical data acceptable to the administrator of the FAA
32
If the holder of an inspection authorization changes his fixed base of operation
he may not exercise the privileges of the authorization until he has notified the FAA flight standards district office or international field office for the area in which the new base is located in writing of the change
33
You just fill out a form 337
when you perform a major alteration or repair
34
Digital manuals and computers maintenance aids
all of the above
35
True/False A certificate and ratings effective for a period of no more than 120 days may be issued to a qualified alllicant pending review of his application and supplementary documents and the issue of the certificate ratings for which he applied
true
36
You are preforming a weight and balance check on an aircraft after a major repair. To find the aircraft center of gravity range you should look in
the applicable type certificate data sheet