問題一覧
1
The airspace directly overlying Fort Worth Meaghan is? Figute 25. Sectional Chart Excerpt. 14. (Refer to area 4)
Class D airspace to 3,200 ft MSL.
2
Which sign is a designation and direction of an exit taxiway from a runway?
K.
3
The term “angle of attack” is defined as the angel between the ?
Chord line and of the wing and the relative wind.
4
Which is the correct traffic pattern departure procedure to use at a noncontrolled airport?
Comply with any FAA traffic pattern established for the airport.
5
To ensure that the unmanned aircraft center of gravity (CG) limits are not exceeded, follow the aircraft loading instructions specified in the?
Pilot’s Operating Handbook or UAS Flight Manual.
6
What is base of Class B airspace at Lakeview (30F) Airport (area 2)?. Gigure 25. Sectional Chart Excerpt. 13.
3,000 ft MSL.
7
When operating an unmanned airplane, the remote pilot should consider that the load factor on the wings my be be increased anytime?
The airplane is subjected to maneuvers other than straight and level flight.
8
(Refer to area 2 Figure 26) While monitoring the Cooperstown CTAF you hear an aircraft announce that they are midfield left downwind to RWY 13. Where would the aircraft be relative to the runway?
The Aircraft is East.
9
Fig 25. (Refer to area 3) If Dallas Executive Tower is not in operation which frequency should be used as a Common Traffic Advisory Frequency (CTAF) to monitor airport traffic?
127.25 MHz.
10
What is the height of the lighted obstacle approximately 6 nautical miles southwest of Savanna International? Figure 23 area 3
1,548 ft MSL.
11
Weather information is available at the Coeur d’Alene (COE) Airport (area 2)
From AWOS 3 135.075.
12
Area C on the airport depicted is classified as a?
Closed runway.
13
(refer to area 2 in Figure 22) At Coeur D’Alene which frequency should be used as a Common Traffic Advisory Frequency (CTAF) to monitor airport traffic?
122.8 MHz.
14
You have been hired to inspect the tower under construction at 46.9N and 98.6w, near Jamestown Reginol (JMS). What must you receive prior to flying your unmanned aircraft in this area.
Authorization from ATC.
15
What is the dotted outlined area northeast of Gila Bend Airport, near area 3?. Figut 75, - Sectional Chart Excerpt 20.
Wilderness area.
16
The NALF Fentress (NFE) Airport is in what type of airspace? (Gigure 20. - Sectional Chart Excerpt .6. (Refer to area 1.)
Class E, Starting at the surface.
17
An airport’s rotating beacon operated during daylight hours indicates?
That weather at the airport located in Class D airspace is below basic VFR weather minimums.
18
If and unmanned airplane weighs 33 pounds, what approximate weight would the airplane structure be required to support during a 30 degree banked turn while maintaining altitude?
38 pounds
19
Sky Way airport is. (Figure 71, area 6)
A non public - use airport.
20
Identify the airspace over Bryan Airport?. Figure 26. - Sectional Chart Excerpt. 17. (Refer to area 2.)
Class G airspace - surface up to but not including 1,200 ft AGL; Class E airspace - 1,200 ft AGL up to but not including 18,000 ft MSL.
21
The angle of attack at which an airplane wing stalls will?
Remain the same regardless of gross weight
22
The lateral dimensions of Class D airspace are based on?
The instrument procedures for which the controlled airspace is extablished
23
When a control tower located on an airport within Class D airspace ceases operation for the day, what happens to the airspace designation?
The airspace reverts to Class E or a combination of Class E and G airspace during the hours the tower is not in operation.
24
(Refer to E) This sigh is a visual clue that?
Confirms the aircraft’s location to be on taxiway “B”.
25
An ATC radar facility issues the following advisory to a pilot flying on a Heading of 360 degrees: “Traffic 10 O’Clock, 2 Miles, Southbound” Where should the pilot look for this traffic?
Northwest.
26
The numbers 8 and 26 on the approach ends of the runway indicate that the runway is orientated approximately?
080 and 260 degrees magnetic.
27
The correct method of stating 4,500 feet MSL to ATC is?
Fout Thoursand Five Hundred.
28
According to 14 CFR Part 107, the remote pilot in command (PIC) of a small unmanned aircraft planning to operate within Class C airspace.
Is required to receive ATC authorization.
29
What is the purpose of the runway/runwany hold position sign?
Denotes intersecting runways.
30
Where is Loup City Manuicipal located with relation to the city?
Northwest approximately 1 mile.
31
What is the approximate latitude and longitude of Cooperstown Airport? (Figure 26, area 1)
47 degrees 25’ N - 98 degrees 06’ W.
32
The chart shows a gray line with “VR1667, VR1617, VR1638, AND VR1668.” Could this area present a hazard to the operations of a small UA?. Figure 59. - sectional shirt Excerpt. 24. (Refer to area 2.)
Yes, this is a Military Training Route from the surface to 1,500 ft AGL and below.
33
You have been hired by a farmer to use your small UA to inspect his crops. The area that you are to survey is in the Devil’s Lake West MOA, east of area 2. How would you find out it the MOA is active?
Refer to the legend for special wise airspace phone number.
34
How would a remote PIC “CHECK NOTAMS” as noted in the CAUTION box regarding the unmarked bolloon?
By obtaining a briefing via an online source such as: 1800WXBrief.com.
35
A stall occurs when the smooth airflow over the unmanned airplane’s wing is disrupted and the lift degenerates rapidly. This is caused when the wing?
Exceeds its critical angle of attack.
36
The correct method of stating 10,500 feet MSL to ATC is?
One Zero Thousand, Five Hundred.