CHAPTER 7C
問題一覧
1
Two conditions that the fuel control for a turbine engine must prevent are:
a. ____________________
b. ____________________
lean die out, rich blow out
2
A turbine engine fuel control meters the fuel by ____________________ (weight or volume).
weight
3
The three types of turbine fuel pumps currently in use are:
a. ____________________
b. ____________________
c. ____________________
hydromechanical, electronic, hydro pneumatic
4
The ____________________ (what device) in a turbine engine fuel control shuts off all flow of fuel to the nozzles when the engine is to be stopped.
shut off valve
5
The fuel control on a Rolls-Royce RB-211 engine operates on a ____________________ (hydromechanical or electronic) schedule until near full engine power.
hydromechanical
6
Full Authority Digital Engine Controls (FADEC) replace with electronics most of the __________ and __________ elements found in other fuel controls.
hydromechanical
7
The two basic types of fuel nozzles used in turbine engines are:
a. ____________________ b. ____________________
atomizing
8
The type of atomizing nozzle that provides a single spray pattern is known as a ____________________ nozzle
simplex
9
The two types of duplex fuel nozzles are:
a. ____________________ b. ____________________
single line, dual line
10
The ____________________ (what type) fuel nozzle causes the fuel/air mixture to vaporize before it exits the nozzle.
vaporizing
11
Rather than using a flow divider in each fuel nozzle, some engines use a single ____________________ valve which acts as a flow divider.
pressure and dump
12
Manifold dumping is a procedure which sharply cuts off combustion and also prevents fuel ____________________ as a result of residual engine heat
boiling
13
The term used to describe idle speed and maximum thrust adjustments made to a turbine engine fuel control is ____________________.
trimming
14
Most manufacturers recommend that all fuel control adjustments be made in the ____________________ (increase or decrease) direction.
increase
15
If the ____________________ (what term) is correct, the fuel control will reach its internal stop before the cockpit quadrant reaches its forward stop.
spring back
CHAPTER 1A
CHAPTER 1A
Dorian Pinuellas · 53問 · 2年前CHAPTER 1A
CHAPTER 1A
53問 • 2年前Dorian Pinuellas
chapter1b
chapter1b
Dorian Pinuellas · 31問 · 2年前chapter1b
chapter1b
31問 • 2年前Dorian Pinuellas
CHAPTER3A
CHAPTER3A
Dorian Pinuellas · 27問 · 2年前CHAPTER3A
CHAPTER3A
27問 • 2年前Dorian Pinuellas
3a part2
3a part2
Dorian Pinuellas · 26問 · 2年前3a part2
3a part2
26問 • 2年前Dorian Pinuellas
CHAPTER4
CHAPTER4
Dorian Pinuellas · 20問 · 2年前CHAPTER4
CHAPTER4
20問 • 2年前Dorian Pinuellas
CHAPTER3B
CHAPTER3B
Dorian Pinuellas · 10問 · 2年前CHAPTER3B
CHAPTER3B
10問 • 2年前Dorian Pinuellas
CHAPTER4B
CHAPTER4B
Dorian Pinuellas · 28問 · 2年前CHAPTER4B
CHAPTER4B
28問 • 2年前Dorian Pinuellas
CHAPTER5B
CHAPTER5B
Dorian Pinuellas · 9問 · 2年前CHAPTER5B
CHAPTER5B
9問 • 2年前Dorian Pinuellas
CHAPTER6B
CHAPTER6B
Dorian Pinuellas · 13問 · 2年前CHAPTER6B
CHAPTER6B
13問 • 2年前Dorian Pinuellas
CHAPTER8E P858-862
CHAPTER8E P858-862
Dorian Pinuellas · 30問 · 1年前CHAPTER8E P858-862
CHAPTER8E P858-862
30問 • 1年前Dorian Pinuellas
CHAPTER8E PART2
CHAPTER8E PART2
Dorian Pinuellas · 24問 · 1年前CHAPTER8E PART2
CHAPTER8E PART2
24問 • 1年前Dorian Pinuellas
CHAPTER8F
CHAPTER8F
Dorian Pinuellas · 14問 · 1年前CHAPTER8F
CHAPTER8F
14問 • 1年前Dorian Pinuellas
CHAPTER7A
CHAPTER7A
Dorian Pinuellas · 12問 · 1年前CHAPTER7A
CHAPTER7A
12問 • 1年前Dorian Pinuellas
CHAPTER7B (PART 1)
CHAPTER7B (PART 1)
Dorian Pinuellas · 18問 · 1年前CHAPTER7B (PART 1)
CHAPTER7B (PART 1)
18問 • 1年前Dorian Pinuellas
CHAPTER7B (PART2)
CHAPTER7B (PART2)
Dorian Pinuellas · 18問 · 1年前CHAPTER7B (PART2)
CHAPTER7B (PART2)
18問 • 1年前Dorian Pinuellas
問題一覧
1
Two conditions that the fuel control for a turbine engine must prevent are:
a. ____________________
b. ____________________
lean die out, rich blow out
2
A turbine engine fuel control meters the fuel by ____________________ (weight or volume).
weight
3
The three types of turbine fuel pumps currently in use are:
a. ____________________
b. ____________________
c. ____________________
hydromechanical, electronic, hydro pneumatic
4
The ____________________ (what device) in a turbine engine fuel control shuts off all flow of fuel to the nozzles when the engine is to be stopped.
shut off valve
5
The fuel control on a Rolls-Royce RB-211 engine operates on a ____________________ (hydromechanical or electronic) schedule until near full engine power.
hydromechanical
6
Full Authority Digital Engine Controls (FADEC) replace with electronics most of the __________ and __________ elements found in other fuel controls.
hydromechanical
7
The two basic types of fuel nozzles used in turbine engines are:
a. ____________________ b. ____________________
atomizing
8
The type of atomizing nozzle that provides a single spray pattern is known as a ____________________ nozzle
simplex
9
The two types of duplex fuel nozzles are:
a. ____________________ b. ____________________
single line, dual line
10
The ____________________ (what type) fuel nozzle causes the fuel/air mixture to vaporize before it exits the nozzle.
vaporizing
11
Rather than using a flow divider in each fuel nozzle, some engines use a single ____________________ valve which acts as a flow divider.
pressure and dump
12
Manifold dumping is a procedure which sharply cuts off combustion and also prevents fuel ____________________ as a result of residual engine heat
boiling
13
The term used to describe idle speed and maximum thrust adjustments made to a turbine engine fuel control is ____________________.
trimming
14
Most manufacturers recommend that all fuel control adjustments be made in the ____________________ (increase or decrease) direction.
increase
15
If the ____________________ (what term) is correct, the fuel control will reach its internal stop before the cockpit quadrant reaches its forward stop.
spring back