laboratory purpose oven specially designed for drying, baking, conditioning and moisture determination.

designed for higher temperature heating

for accurate moisture reading on site of soil, sand, aggregates

use for field determination of the amount of surface moisture in fine aggregates.

device for separating wanted elements from unwanted material or for characterizing the particle size distributions of sample.

operated for sieves when perform sieving tests.

designed the reduction of test samples which are – for too large in volume to be conveniently handled. It divides samples so that half is representative of the original whole sample.

used to determine the resistance to abrasion and wear of cement, concrete and similar materials.

is used for rock classification tes . – ts

used to determine the resistance of aggregates by – abrasion

used to determine the resistance t – o abrasion and wear of cement, concrete and similar materials

used to determine the quality of aggregates by abrasion

designed to reduce to powder any sort of granulometric material (clinker, cement, stones, hard materials) for general purpose laboratory tests.

designed to mix dry materials like: powders, cement, gypsum and granulometric materials. In a short time it assures a perfect and homogenous mixture.

suitable to determine the abrasion resistance of glazed tiles and other materials

used to measure resistance of an aggregate to crushing under a gradually applied compressive load.

used for specific gravity and water absorption test.

design to remove a cylinder of material, much like a hole saw.

to thrust out; force or press out.

used to determine the strength and slope stability of rock size

used to test the effects of specified environmental conditions.

use for splitting breaking rock.

used to perform compression test on concrete bean – specimens.

used to perform flexural tests on concrete beam specimen

used to determine the strain and deformation – characteristics of concrete specimens.

suitable for field mixes of medium strength concrete

for the determination of the consistency, the medium and high workability of fresh concrete.

Vebe consistometer method is based on the same principle of the simple slump cone test method, for the determination of the workability of concrete, but it has the advantage of a mechanized action after removing the slump cone, the concrete undergoes a vibration to determine its slump. A space disk set in contact with the upper surface of the wet concrete, gives the operator the opportunity to determine when the compaction is complete. The operator will count the time necessary to complete the requested vibration, so as to get an indication of the workability of the concrete.

designed to undertake a more precise and sensitive test procedure than the simple slump test

to determine the degree of compaction and the workability of fresh concrete. Used for in-situ measurements of inside test molds. Test results can be correlated against the slump values.

used to determine the workability of concrete.

it is used to determine the workability of fresh concrete. The ball is lowered into the concrete and the penetration measured. It can b

the concrete workability meter (also known as plastometer) is designed to test concrete for dynamic workability.

used for quick and easy measurement of the plasticity of mixtures especially concrete, and so to detect rapidly any excess of water. The measuring system is related to the shear strength applied by a three blade heads to the mixture under test.

used to determine the setting time of the mortar fraction in concrete mixes with the slump greater than zero, by testing mortar sieved from mix.

it records directly the percentage of air enclosed in freshly mixed concrete by operating according to the air pressure principle.

used to determine the weight per cubic meter of freshly mixed and compacted concrete.

used to separate the various elements of the fresh concrete such as cement, sand, aggregates.

used for the determination of cement content in fresh concrete , coarse and fine aggregate, fly ash and GGBF slag content can also be determined.

used in molding