問題一覧
1
A jointer
2
All of the choices are correct
3
Replacement of an autopilot with part manufactured with approved drawing is considered?
Appliance major repair
4
Aircraft major alteration
5
15 to 30 days suspension
6
Total service of the airframe
7
Which statement is correct regarding an aircraft that is found to be not airworthy after an annual inspection, due to an item requiring a major repair? (assuming the approved data is issued to accomplish the repair)
An appropriately rated mechanic may accomplish the repair and an IS may approve the aircraft for return to service
8
Make of aircraft, model, serial number, nationality and registration
9
It does not require a STC when in an alteration
10
The repair of damaged areas in the plywood stressed covering exceeding (6) inches in any direction
11
A private pilot license
12
The form and manner prescribed by the CAAP
13
Airframe minor repair techniques
14
If special permit has been issued for the aircraft
15
An appropriate licensed aircraft mechanic
16
Airframe shall mean
Any and all kinds of booms, landing gear, empennages, fairing or control of fuselage, booms. Empennages, nacelles, fairings, cowlings and control surfaces
17
Which is not considered an airframe major alteration?
Strengthening or reinforcing the fuselage longeron
18
PCAR Part 6
19
A repair
20
Repair made on the hydraulic/pneumatic system is considered
An airframe minor repair
21
Revocation
22
Aiframe minor alterations
23
7 Consecutive Days
24
The date of the inspection and aircraft time in service
25
14 CFR Part 91
26
Airframe major repair
27
Appliance minor alteration
28
Disassembly of float type carburetor
29
By the holder of an inspection authorization
30
An appropriately rated mechanic may repair the defects and approve the aircraft for return to service
31
Airframe minor repair
32
If necessary to reach a place at which the inspection can be done
33
10 hours
34
An airframe major repair
35
Which statement about Airworthiness Directice (AD’s) is true?
Compliance with an appliacable AD is mandatory and mus t be recorded in the maintenance record
36
If necessary to reach a place which the inspection can be accomplished, but not to exceed 10 flight hours
37
Aiframe and powerplant ratings
38
Disassembly of float type carburetor
39
All of the choices are correct
40
48 hours
41
Wing and control surface fairings
42
In accordance with an inspection program authorized under Federal Aviation Regulation Part 91, Subpart E
43
Modification to basic design of the exhaust system is considered
Aiframe major alteration
44
Direct supervision