問題一覧
1
The fall height of an embankment slide in the slide, exit use zone shall be a minimum of:
40 inches
2
The criteria for unitary surface materials includes meeting requirements of:
ASTM F1292 and F1487
3
A spring rocker with seat height of 26” is about to be installed adjacent to the side of a fully enclosed bucket seat sweater swing, set the minimum distance between the bucket swingset, and the rocker is:
108”
4
It is recommended that which of the following be included in the site history file for a playground:
Manufacturers, contact, information, audit, reports, copies of complaints, accident/injury summary reports.
5
Which of the following are the most appropriate tools to test for partially bounded opening?
Wedge/fish template, part A and B
6
Which of the following would be the BEST location for a new playground?
At a well drained area
7
Which of the following sections on the swing seat should be tested for possible protrusions? 1. Rear 2. Front 3. Sides 4. Bottom
1, 2, and 4 only
8
A CPSI’s records, the following data while performing a safety audit on a playground intended for preschool children ages 2 to 5: a transfer platform 20 inches, (500 mm) above the surface space. adjacent platform is 24 inches (610 mm) apart with no access component space. a guard rail on a 3 foot (36 inch 914 mm) high platform space a 22 inch 509 mm opening on an elevator instructor. Which of the following should the CPS I recommend an order to maintain compliance?
Raise the surface into with an 18 inches, (457 mm) of the transfer platform, installing access component between the adjacent platforms, replace the guard rail with a barrier, and install a horizontal top rail on the opening.
9
The standard that is used to determine whether Playgrounds surfacing is firm, stable, and slip resistant is:
F1951
10
For which of the following has a fall height as the maximum height of the structure?
Horizontal ladder
11
Which of the following noted during an examination of a neighborhood playground would be considered a Priority 1 safety concern:
a vertical projection extending 1/4” (6.4 mm) from the top rail of a swing support structure.
12
A freestanding, three dimensional climbing net structure has a Center post that reaches an elevation of 84 inches, and interior fall height measured at 68 inches, and an exterior fall height measured to be 48 inches. What is the fall height of this piece of public playground equipment?
84 inches
13
When installing climbing ropes over engineered, wood, fiber, the rope should:
Be secured at both ends.
14
For the overhead swinging rings, the length of the chain must not exceed 7 inches in the overall length must not exceed:
15 inches
15
What establishes the public playground owners standard of care for the risk management program?
Safety policy
16
An opening may present a common crush, or sheer hazard only effort:
Grabs the 5/8 inch doll
17
Upon doing a routine inspection, a maintenance worker finds a badly cracked. Child swing seat. There is no other seat available. The maintenance worker should:
remove the swing chain and seat.
18
Which of the following has the greatest potential to create a priority one hazard on a 120 inch (3050 mm) long embankment slide
Slide shoot clearance zone less than 15 inches (380 mm)
19
A playground safety audit should be performed by someone who:
Is knowledgeable of current standards and guidelines.
20
Which of the following statements regarding fasteners and other hardware is true?
Fasteners another hardware must be corrosion resistant, or have a corrosion resistant coding.
21
Step in forms for preschool age children must be permanently affixed, and shall have a hand support if the step is greater than :
20 inches, (508 mm)
22
A CPSI’s conducts, an audit of a public playground without the authorization, or cause one of the Playgrounds owner. The CPSI has violated the:
Certified Playgrounds safety inspector code of professional conduct
23
Which of the following is correct regarding the impact-attenuation of surface material?
Critical height must equal or exceed fall height.
24
The fall height of an embankment slide in the slide exit used zone shall be a minimum of:
40 inches
25
Which of the following is covered by ASTM F1487?
Public use playground equipment
26
Which of the following is a hazard associated with truck rides when the rolling portions of the hand gripping it is not enclosed ?
Crush and shear points
27
How should the CPSI determine the impact attenuation of the poured-in-place safety surfacing when auditing a playground?
Verify the document from the manufacture .
28
Which of the following statements is correct regarding the guard rail design? Or are
Horizontal infill cross-pieces should be spaced no farther than 3.5 inches apart.
29
A child sustains, a serious head injury at a playground. The playground owner has performed regular safety inspections, but has not documented his inspections, or any corrective actions taken. The owner is now subject to possible accusations of:
Negligence
30
All of the following are helpful when conducting a playground inventory, except:
Head and torso probes
31
Heights of guard, rails and protective barriers are determined by which of the following characteristics of children?
Center of gravity
32
To be compliant with ASTM 1487, a designer or manufacturer playground equipment should provide buyers:
A parts list for the playground
33
The purpose of performing, documenting, and retaining playground inspections is:
To maintain the standard of care and identify new hazards resulting from changes to the playground