You may be considered a Negligent Operator of a commercial vehicle if your driving record shows the following “point count” ________.

All motor vehicles shall be equipped as to permit application of the brakes at least _____ for the purpose of bringing the vehicle to a stop within the legal stopping distance after the engine has become inoperative

An original applicant for a certificate to drive a school bus shall have successfully completed a minimum ______ hour course of instruction

Recapped or retreaded tires shall have been recapped or retreaded no more than _____ time(s).

Danger Zones may extend as much as 30 feet front bumper with the first _____ feet being the most dangerous.

Applicants seeking to renew their school bus certificate shall complete at least _____ hours of original or renewal classroom instruction or in-service during each 12 months of certificate validity.

When does the driver begin and end their responsibility for the pupils transported on their school bus ?

If you miss a student’s unloading stop you shall ______

A school bus should stop at least ____ feet away from students at a designated stop

The Safety Circle consists of the Accident Zone, the Zone of Action and ________.

Inspection or servicing of school bus fire extinguishers shall be done at ______ intervals.

If you have worked for any other employer during a 24 hour period prior to your report to work time, your are required to report the additional on-duty time _______.

Wheelchair school buses shall have at least _______.

Required tread depth on the steering axle of a school bus is a minimum of _______ of an inch

When evacuating a school bus, lead students up wind of the bus at least ____ feet if there is a risk from spilled hazardous materials

The school bus flashing red signal lights and stop signal arm should not be operated at _______.

Students shall only cross the street when ______.

Ventilation on a school bus shall be adequate to assure a complete change of air at least one every _____ while the bus is moving

The minimum requirement for school buses (non-wheelchair) is that they shall be equipped with one or two extinguishers having an aggregate rating of not less than _____.

Which of the following mirrors are not required on school bus?

While driving at night you should dim your lights ____.

When driving a slow moving vehicle on a highway (two lane), you must use turnouts to allow other vehicles to pass when there are ______ or more vehicles behind you.

Tie bars, humps and fillets are located where ?

It is a good practice to do the following when unloading students:

A skid can be caused by ________.

Recapped or retreaded tires ________.

CHP approval is needed if a school bus stop is upon the main traveled portion of a highway where there is not clear view of the stop from _____ in each direction along the highway if the speed limit is more than _____.

Cut-out pressure for full air brake system shall not be more than ______ psi

No fastener on a wheelchair bus shall project more than _____ above the floor in an area between the wheel wells of the vehicle

An original applicant for a certificate to drive a SPAB shall have successfully completed a minimum ______ hour course of instruction consisting of ______ hours of classroom and _______ hours of behind the wheel training.

To upgrade a SPAB certificate to a school bus certificate the driver shall complete a minimum of ______ hours of classroom instruction and at least ______ hours of behind the wheel

Tires ____ be used with boot or blowout patches

Brake failure occurs mainly due to ________.

Pupils transported in a school bus or SPAB shall be under the authority of and directly responsible to _______.

On approach to school bus stop where pupils are loading or unloading from a school bus, the school bus driver shall activate an approved amber warning light system, if the bus is so equipped, beginning _______ feet before the school bus stop.

The area between your stopped vehicle and the vehicle in front of you is called _______.

A passive railroad crossing _______.

Re-grooved tires ____.

All training required for drivers to maintain a school bus certificate shall be properly documented on the State Department of Education Training Certificate _______.

First Aid kits shall be constructed to prevent _______ from reaching the contents and maintained in good condition.

The speed limit is ______ mph when you come within 100 feet of a railroad crossing and cannot see for ______ feet in both directions

All readily accessible exposed edges or other hazardous protrusions on part of lift assemblies located in the passenger compartment of a wheel chair school bus shall be padded to whitin _______ of the floor.

Each seat cushion on a school bus shall be fastened to the seat frame by not less than ______ positive locking devices at the front or rear of the cushion

Reaction time is the time elapsed between _______.

During the last 12 months of the special driver certificate validity shall complete ______ hours of ______ instruction

What is the empty space around your school bus called ?

You may not overtake and pass another vehicle which is moving at a speed less than 20 mph on a grade outside a business or residential district unless you can pass it traveling at least _______.

ABS means _______.

A school bus with a maximum capacity of 16 shall carry a first aid kit containing ______ units.

Fasteners shall contact the wheelchair on at least _____ points.

A wheelchair school bus shall be equipped with ______ extinguishers, each one rated at not less than _______.

Every motor vehicle equipped with a pressure gauge accurate within _____ percent of the actual air pressure reservoir

If the gate at a railroad crossing comes down after you have started to cross the track you should _______.

School buses shall be equipped with mirrors on both the left and right-hand sides of the vehicle so located as to reflect to the driver a view of the highway through each mirror for a distance of at least _____ feet to the rear of the vehicle

When a school bus is stopped for the purpose of loading or unloading pupils who need to cross the highway or private road upon which the school bus is stopped, the school bus driver shall escort all pupils in _________.

Elements that prevent a driver and the vehicle from becoming involved in a collision are _______.

The Vehicle Safely Inspection Approval Certificate on a school bus shall be signed and dated within the past ______ months.

A sign that is yellow with black writing at a railroad crossing is ____ for school buses when transporting pupils.

School bus fire extinguishers shall be inspected and serviced only by a person, firm or organization authorized to do so by the _______.

An active railroad crossing has ______.

If the mirrors or the body of the school bus cause a blind area for the driver, what should the driver do?