a water heater is classified as?

Elastomeric gasketed and rubber-ring joints shall comply with _____ installation standard

The birth of the plumbing profession in the Philippines is traced back to the ___ century.

Depth of the molten pig lead in a caulked joint

Each fixture directly connected to the drainage system shall be equipped with a _____

IPS shall be supported at ___ intervals for piping 19 mm diameter and smaller

for IPS piping 25 mm and larger, support intervals shall be ___

What section of RA 1378 enumerates the qualification for persons applying for examination?

The year when NAMPAP was organized and registered with the Securities and Exchange Commission

What will happen if a drainage piping is placed at slope of 10mm/m due to structural conditions?

A hose connection with two-gated outlets permitting two connections of the same or smaller coupling diameter to be taken from a single supply line

The Plumbing Code has been in existence for almost _____ since its promulgation before it has been amended

The Administrative Authority must be notified at least ___ working days before such inspection is intended

Any change, addition or modification in construction or occupancy

the reconstruction or renewal of any part of an existing building for its maintenance

The distance of water closet or bidet center to center

Distance of water closet or bidet center to side

Distance or urinal to urinal center to center

Distance of urinal to side wall center to side

All plumbing plans, drawings, diagrams, etc. shall be submitted in ___ sets for permit application

Date of the Accreditation of NAMPAP

trap arm size of wash basin (lavatory) single, dental units or cuspidor

trap arm size of floor drains, grease interceptors, showers, etc.

trap arm size of water closet

Preferred when a piece of pipe needed is shorter than 150 cm long

used for a well-fitted hub and spigot connections

recommended when the length of a pipe needed is more than 150 cm long wherein cutting is not necessary

used in lieu of the single hub to do away with caulking of joints

a registered master plumber must not supplant another Registered Master Plumber after definite steps have already been taken toward his/her being commissioned to perform the contract

A pipe flange that is not drilled for bolt holes

The Old Fire Code of the Philippines

Creation of Professional Regulation Commission

The 2008 Fire Code of the Philippines

National Building Code of the Philippines

Which authority is responsible for the administration and enforcement of the National Plumbing Code?

in-charge of the enforcement and implementation of RA 1378 and its IRR.

(ANSI) Pipe Color code for Fire Quenching

(ANSI/ASME) Pipe Color code for Toxic or Corrosive liquids, acids (Nitric Acid)

Each member of the board, shall at the time of his appointment be at least _____ of age

An open return bend usually made up of two 90° bends

Code on Sanitation of the Philippines

Philippine Mechanical Engineering Act of 1998

Philippine Clean Air Act

Fire Code of the Philippines

Copper tubing shall be fully externally protected with a/an _____ and fiberglass wrapping installed inside a split rigid casing whenever installed underground.

protection from breakage for piping passing under or through walls

protection from external corrosion for pipes passing through or under cinders or other corrosive materials

Voids between pipes and sleeves through concrete floors in the ground shall be appropriately sealed with _____.

for pipes directly embedded in concrete and masonry walls

Integrated within an air accumulator vessel which is designed to discharge a predetermined quantity of water into fixtures for flushing purposes

A tank located above or integral with water close3t, urinal, or similar fixtures for flushing or removing excrements in the fixture

A device located at the bottom of the tank for the purpose of flushing water closet and similar fixtures

A device with discharges a predetermined quantity of water into fixtures for flushing purposes and is actuated by direct water pressure

ASTM means?

A pipe or conduit for carrying sewage and wastewater

Vertical support of _____ is placed not less than every other storey height

Vertical support of _____ is placed every 1 meter

Vertical support of _____ is placed each storey or maximum 3 meters on center

Vertical support of _____ is placed every storey or closer

Common maximum service temperature rating of PVC

CPVC: maximum temperature rating is______

1 fixture unit is equal to?

Who is the current chairman of the Board of Examiners for Master Plumber?

What is the accreditation number of NAMPAP?

A plumbing permit shall become null and void if the plumbing work has been suspended or abandoned for a period or _____

Tube made of plastic material and colored black. The cross-sectional shape is normally oval and is denoted by its outside diameter or 0.D.

For caulked-on closet ring, the minimum overall depth shall be

Caulked-on closet rings or closet flanges shall not be less than ____

Color for Type M copper pipe

Copper tube for water supply piping shall have a weight of not less than _____.

The top edge of a receptacle from where water overflows

What is not included in a plumbing unit? - kitchen sink - urinal - laundry tray - hose bibb

Wiped lead joints shall have an exposed surface on each side of a joint not less than _____

Every building where _____ shall have a sewer service connection to a public or private sewer systems

In a plumbing unit, how many floor drains are included?

An adjustable tubing connection, consisting of a compression nut, a friction ring, and a compression washer, designed to fit a threaded adapter fitting or a standard taper pipe thread

Minimum weight of a lead for flashing or vent terminals

This examination subject in Master Plumbing was originally split into two

Distance of bottom of all pipe tranches to the footing of any adjacent building or structure parallel to it

Trap arm size of a laundry tub