Simple or minor preservation operations and the replacement of small standard parts not involving complex assembly operations best describes:

The holder of a repairman certificate may not supervise the maintenance, preventive maintenance, or alteration of aircraft or aircraft components.

FAR Part 65 covers

Which of the following is not a category of AD’s?

The application form, to become a certified mechanic, is Form ____.

A discrepancy with different rudder rigging travel limits between an aircraft’s TCDS and the aircraft manufacturers maintenance manual, follow the manufacturers maintenance instructions.

A mechanic must hold their license for ____ years to be eligible for an Inspection Authorization.

A powerplant mechanic may perform a major repair to an aircraft engine but a ____ is required to return it to service.

When performing an annual inspection, you must use a checklist that at a minimum covers the items specified in:

The primary difference between the mechanic certificate and the repairman certificate is that the mechanic can perform more difficult repairs than the repairman.

Filling out an FAA Form 8010-4 Malfunction or Defect is:

Temporary records

Digital manuals and computer maintenance aids:

A conviction, for the sale of marijuana, may result in your mechanic certificate being suspended or revoked.

ATA stands for

Repairing an altimeter is a privilege of the airframe mechanic.

A certified A&P mechanic may approve and return to service an airframe, powerplant, or propeller or any related part or appliance,

Advisory Circular AC 43.13-1B Change 1 differs from other Advisory Circulars because:

To be eligible for a repairman certificate (experimental aircraft builder), an individual must —(Which of the following does not apply?)

The holder of an inspection authorization may supervise a progressive inspection

FAA AC 43.13-1B can be used as approved data to repair an aircraft that had a defect not covered within the manufacturer’s maintenance manuals.

A part manufacturered for installation on an FAA certificated aircraft by a person other than the aircraft manufacturer may be approved under the provisions of a/an

If the holder of an inspection authorization changes his fixed base of operation,

Which is correct about an AD numbered 1996-12-10 R?

To be eligible for a repairman certificate (experimental aircraft builder), an individual must— (Which of the following is not true?)

An airframe and powerplant mechanic may perform, and return to service, a 100 hour inspection on an aircraft, propeller, and engine.

The mechanic ratings include _____ and _____.

Of the two following statements: A. FAA Advisory Circulars are never binding B. A high premature failure rate amongst an aircraft’s pitot tubes may be brought to your attention through an airworthiness alert

The two methods by which an applicant for a mechanics certificate may retake a failed written test include ____ and ____.

Propeller knowledge and testing would be included in what rating?

FAR Part 21 covers

If you ______ your mechanic certificate, this means you return it voluntarily.

As part of an annual inspection, you should check on the status of pertinent Airworthiness Directives for the aircraft you are inspecting. You should look in:

A certificated mechanic may not exercise the privileges of his certificate and rating unless, within the preceding 12 months— (a) The Administrator has found that he is able to do that work; or (b) He has, for at least 6 months— (1) Served as a mechanic under his certificate and rating; (2) Technically supervised other mechanics; (3) Supervised, in an executive capacity, the maintenance or alteration of aircraft

According to FAR Part 43, changing the landing gear wheels of a Cessna 150 to floats would be considered:

Compliance with Airworthiness Directives:

Refusing to submit to drug and alcohol testing is _____.

STC stands for

An airframe certificated mechanic may perform the entire 100 hour inspection upon an aircraft and return it to service

Service bulletins are not issued to notify others of:

Consider the following two statements: X. An NPRM provides a comment period where you may provide your own input by submitting data, views or arguments for or against Z. A major change can be submitted to the FAA to a previously approved design type as long as the change doesn’t require a new type certificate

Given the following two statements: X. Malfunction or Defect Reports give the general-aviation community information to indentify service difficulties and safety problems found during maintenance. Z. Advisory Circulars inform the aviation community, in a systematic way, about regulatory information of interest

The recent experience requirements of the mechanics certificate may be fulfilled through supervising maintenance or alteration of aircraft.

Airworthiness standards for helicopter rotor blades would be located in which FAR?

Compliance requirements are established for safety reasons and may be stated in many different ways, one way that is not used would be:

A repairman certificate is no longer effective once the holder is relieved from the duties for which the holder was employed and certificated

A mistake in recording the part number, of a part installed on an aircraft, if unintentional, is cause for revoking a mechanics certificate.

When a mechanic exercises the privileges of an inspection authorization he shall keep it available for inspection for which of the following:

Cheating on an FAA exam nah be tolerated if certain requirements are met and the FAA administrator is familiar with your limitations.

Which of the following does not apply? To be eligible for an inspection authorization, an applicant must—

Each inspection authorization expires:

When do emergency AD’s become effective?

The FAA requires a fixed base of operation for an Inspection Authorization to be approved.

The approval for the manufacture of a component for use on a certificated aircraft is covered in which FAR?

When an aircraft owner presents evidence that his aircraft conforms to its type certificate, and any Supplemental Type Certificates and Airworthiness Directives, the FAA will grant him:

A large air carrier is certificated under which part of the FARs?

Where can you find aircraft data and specifications for certificated aircraft when there are only 20 registered?

To find information on your rights, privileges, and limitations as a certificated mechanic, you should refer to:

An A&P rated mechanic may do which of the following:

Who is responsible for the compliance with AD’s?

Which of the following is NOT required to be entered in the permanent aircraft records:

The FAA must be notified within ____ days of change of address of any person holding a mechanic certificate.

The mechanic, and the repairman certificates are considered to be different classifications by the FAA

You have completed a major alteration on a costumer’s aircraft. What should you do with copies of the 337 form?

The FAA stands for

The main point of contact between the FAA and an individual technician is the

A costumer brings you a rare antique aircraft for an inspection. The best source of information on this aircraft would be:

When returning an aircraft to service after an inspection, which item is NOT required to be entered in the permanent records?

The mechanic certificate must be renewed each year or it will expire

Which is not a category in that AD’s are published?

A certificate and ratings effective for a period of not more than 120 days may be issued to a qualified applicant, pending the review of his application and supplementary documents and the issue of the certificate and ratings for which he applied

A conviction for the violation of any Federal or state statute relating to the growing, processing, manufacture, sale, disposition, possession, transportation, or importation of narcotic drugs, marihuana, or depressant or stimulant drugs or substances is grounds for— (Which of the following is true?) (1) Denial of an application for any certificate or rating issued under this part for a period of up to 2 years after the date of final conviction; or (2) Suspension or revocation of any certificate or rating issued under this part

Refusal by the holder of a certificate issued under this part to take a drug test required under the provisions of appendix I to part 121 or an alcohol test required under the provisions of appendix J to part 121 is grounds for — (Which of the following is true?) (1) Denial of an application for any certificate or rating issued under this part for a period of up to 1 year after the date of such refusal; and (2) Suspension or revocation of any certificate or rating issued under this part

___ months of practical experience, working on aircraft, are required to apply for the airframe and powerplant certificate, if the applicant has not attended a certified school.

To apply for a mechanic certificate or rating, an applicant may provide documentary evidence that attest to ___ months of practical experience equally performing the duties of both airframe and power plant duties.

Airworthiness directive #2003-18-10 was issued

A “TSO” stamp on a part means

Service Bulletins (SB)

What is the minimum passing grade on all FAA exams?

Are you required to notify the FAA when an AD has been accomplished?

FAR Part 91.417 requires that the aircraft maintenance records contain the current status of applicable AD’s excluding

Which of the following does not apply? Each applicant for a mechanic certificate or rating must present:

An aircraft overflew its 100 hour inspection by two hours reaching your inspection facility. You complete your inspection and return it to service. You record the next 100 hour inspection as being due in ___ hours.

Which of the following does not apply? To be eligible for a repairman certificate a person must—

Helicopter rotor blades are certificated under 14CFR Part

A certified mechanic must be at least __ years of age.

Aircraft that operated under a progressive inspection program are required to undergo an annual inspection every year

Falsely reproducing aircraft records can result in _______.

Which of the following items does not represent an AD applicability?

14 CFR Part 65 relates to the certification of airmen other than ______ crew members.

A manufacturer’s service letter may be used as justification to facilitate a repair different from one mandated by an AD as long as it accomplishes an acceptable level of safety as the requirements of the AD

Advisory Circulars (AC)

Information distributed to the maintenance technicians in the form of Airworthiness Alerts is gathered from

Which of the following does not apply? To be eligible for a mechanic certificate and associated ratings, a person must—

Maintenance managers, that request shortcuts to be made in repairs or maintenance, will always stand by their requests under oath in court.

How may emergenct AD’s be distributed?

A person whose mechanic or repairman certificate is revoked may not apply for either of those kinds of certificates for two years after the date of revocation.

You are performing a weight and balance check on an aircraft after a major repair. To find the aircraft’s center of gravity range, you should look in:

A standardized organization of maintenance information is found in

A mechanic with only an airframe rating may obtain an inspection authorization valid only for the maintenance, inspection, repair, & alteration of the aircraft airframe.