when constructing a bulkhead with suspended ceiling Components, what would you fasten it with?

stucco requires us to install an ___________ as a sheathing membrane over wood frame walls

When installing a steel door frame, how many anchors should be installed on each side of the door?

Long, tall walls, where the brick is the cladding require the addition of ?

The shoe on a lintel must extend a minimum of

compression anchors are used at the top of knockdown frames, and they can keep the miters

Lightweight steel stud gauge is ?

Clapboard or bevel sliding can have the

When using a Spiral saw the correct direction of operation is

The maximum spacing, when installing resilient channel is ?

For an inside curve, the drywall is ?

Steel stud framing can be

When chalking a line for a wall angle, where do you mark?

When installing drywall in a house, we always start boarding the

And interior wall with casings is most commonly used with ?

The screws for fasting drywall should penetrate how far through the steel stud ?

Heavyweight steel stud is ?

The building code says that when installing vertical wood siding we must have a ___mm clearance above the ground

Corner consisting of two studs is called a ?

A suspended drywall ceiling system require

The main purpose of a built up roof is to contain the

Final siding has a high expansion and contraction factor due to

If installing hangers for an expose suspended ceiling system, the maximum spacing is ?

A curtain wall is a non-load bearing wall that supports itself and ?

The maximum spacing of furring channel is?

Two types of demountable partition systems are?

Type X gypsum board is used to protect framing from

A can’t strip is used to create

Three coats of stucco are supplied. What are the three different coats?

Spreaders are used to maintain____ when the door frame is installed on a block wall

The best type of wood for exterior finishes would be ?

Scupper is an opening in a roof at the

Steel stud wall studs in a fire, rated assembly are cut how much shorter than the actual wall height ?

The shims should be placed closer to the barrel side of the hinge if you want to

Panel edges must not be placed in line with the

Tracks must be the same gauge, or heavier than

The rain screen principle is a method of cladding that

What gauge steel is used for steel door frames?

Main tees are installed running the

Taping compounds or adhesives can be used for

Expansion joint is incorporated into main teas for fire rated assemblies, what what else is installed?

Border tile should be a minimum of

Aviation snips would be best suited for cutting ?

Corrosion resistant nails must be used for

Studs can be secured by

Tracks installed on exterior walls must be fastened with a minimum of ?

Suspended ceilings can be

Screws should be spaced how far from the edge of the panel ?

Plaster grounds are used to control the

Leading edge of a panel is fastened to the

Tracks installed for interior walls must be fasten with a minimum of ?

In a built up roof system if that insulation is installed below the roof deck we would be required to incorporate an

How many attachment points are needed for each side of an interior knock down frame ?