The definition of a qualified person is ___.

Which of the following is NOT a cause for a generator to vibrate

any interruption of the circuit, even circuits as low as ___ volts, either by any switch, or loose or defective connections anywhere in the circuit, may produce a spark sufficient to ignite flammable anesthetic agents.

When calculating the conductor fill for strut-type channel raceway with internal joiners the raceway shall be permitted to be filled to ___ percent of the cross-sectional area

An oil switch is a switch having contacts which operate under ___. i.askarel ii.oil iii.other suitable liquids

On s delta connected 3Ø, 4-wire system the phase arrangement for the busbar with the highest voltage to ground is ____ .

The wheatstone bridge method is used for accurste measurements of ___

A transformer would most likely have a ___ efficiency

An electrician should not wear shoes that have sponge rubber soles while working mainly because they ___

Branch circuits for heating and air conditioning equipment located on the elevator car shall not have a circuit voltage in excess of __ volts.

Type ITC cable is permitted to be used in industrial establishments with proper supervision in which of the following? I. aerial cable on a messenger Il. cable trays III. with nonpower-limited circuits

Identified, as used in the CODE in reference to a conductor or its terminals, means that such a conductor or terminal is to be recognized as ___

To determine directly whether all finished wire installations possess resistance between conductors , and between conductors and ground, use ___.

When thermal overload relays are used for the protection of poly-phase induction motors, their primary purpose is to protect the motors in case of ___.

The voltage produced by electromagnetic induction is controlled by ____.

The important function of a type S-fuse is ___

Sensitivity of the voltmeter is expressed in

The speed of a synchronous motor

PEE, REE and RME whose Certificate of Registration has been revoked may, after the lapsed of from the surrender thereof, be re-issued upon approval of the Commission.

The rating of a storage battery is expressed in __

The field winding of a self-excited generator is supplied from

Units of apparent power

Boxes and fittings shl be ___ in a class III, Division * location

A substance whose molecules consist of the same kind of atoms is called ___

Exposed non-current carrying metal parts of fixed equipment must be grounded under all of the following conditions except ___

A nameplate data that will tell whether or not the motor is allowed to develop more that its rated nameplate horsepower without causing deterioration of its insulation.

An appliance, which is fastened or otherwise, secured at a specific location

An auxiliary gutter shall not extend a greater distance than ___ feet beyond the equipment which it supplements

The horsepower rating of the disconnecting means of hermetic refrigerant motor-compressors shall be determined from the ___ I. nameplate rated-load current II. branch-circuit selection current III. loads

Which one refers to the generator’s mechanical driver?

The definition of accessible (wire)

The branch circuit overcurrent devices in emergency circuitd shall be ___

Artificial respiration after a severe electrical shock is necessary when the shock results in ___

Reactance will cause the current in a circuit to vary only when ___

The term “15-ampere” is commonly used in identifying a/an

The advantage of AC over DC incudes which of the following?

A fuse puller is used in replacing

The resistance of an electrical conductor is inversely proportional to its ___.

Which of the following motors does not have a commutator

A manufactured assembly designed to support and energize lighting fixtures that are capable of being readily repositioned is ___

Fire protective signaling circuits shall be grounded the only exception is Dc power-limited circuits having a maximum current of __ amperes

A cord connector that is supported by a permanently installed cord pendant shall be considered a (an) ____

Flexible cords to portable electricity heated appliances rated at more that ___ watts shall be approved for heating cords

Bare conductors on a 30 volt lightning system shall not be installed less than ___ mm above thee finished floor, unledd ghe listed for a lower height

Except where computations result in a major fractions of an amphere __, such fractions may be dropped

Hoist way is a ___ in which an elevator or dumbwaiter is designed to operate

Autotransformers used to start large induction motors are frequently called starting ___

What would be the advantage of 240 volts rather than 120 volts on a load with the same wattage?

A motor with a wide speed range is a(n) ___

A circuit breaker that has purposely introduced into it a delay in the tripping action and which delay decrease as the magnitude of the current increases is a ___ circuit breaker.

This refers to the choice of electrical systems, including planning and detailing of requirements for protection, control, monitoring, coordination and interlocking of electrical systems among others

A type of AC motor that runs at a constant speed and is used for such purposes as an electric clock motor is a ___ motor.

It ids generally recognized that ___ is the largest size EMT hand bender

A piece of electrical equipment that is designed to operate at alternate intervals of (1) load and no load; or (2) load and rest; or (3) load, no load, and rest is called __ duty.

This refers to department stores, supermarkets, shopping malls, office buildings, hotels, theatres, stadiums, condominiums, conventions, convention centers, restaurants and the like, used for business or profit

A switch or breaker should disconnect the grounded conductors of a circuit __

Typical output of a lead acid cell.

The connection of a ground clamp to a grounding electrode shall be ___

Counter emf is measured in

__ are permitted to protect motor branch circuit conductors from overload. I. Thermal relays II. Inverse time circuit breakers III. Time delay fuses

For open conductors of not over 600 volts, clearance from ground shall be __ mm, above finished grade where the supply conductors have a nominal voltage limited to 150 volts to ground and accessible to pedestrians only.

A switch or circuit breaker should disconnect the grounded conductors of a circuit ___

What is the VA input of a fully loaded 5hp 230 volt single-phase motor?

When using compressed air to clean electrical equipment, the air pressure should not exceed 50 pounds. The main reason is higher pressures ___.

All lights and any receptacles adjacent to the mirror(s) and above the dressing table counters in dressing rooms of theaters shall be controlled by wall switches installed in the

all wiring must be installed so that when completed

The wattmeter/s necessary to measure the power in the load of an unbalanced 3-phase, 4-wire system is __

Locknuts are sometime used in making electrical connections on studs. In these cases fhe purpose of the locknuts is to ___

In a D.C circuit, the ratio of watts to volt amperes is ___

___ cable shall be flame retardant, moisture-resistant, fungus-resistant, and corrosion-resistant

The load in an electrical circuit is use to ___

Fluorescent lighting fixtures may be used as raceways if ___

An appliance that is not easily moved from one place to another in normal use is a _ appliance

A common fuse and circuit breaker works on the principal that ___

The length of a type S cord connecting a trash compactor must nit exceed ___

When installing a type FCC system under carpet squares, not more than ___ crossing of cable runs shall be permitted at any one points

The input to a motor is 16,000 watts and the motor loses a total of 3,000 watts. The efficiency of the motor is most nearly

____are typically used as enclosures for splicing or terminating telephone cables. I. splice cases Il. terminal boxes IlI. octagonal boxes

The output voltage of a single loop generator is a ___

The process of adding impurities to a pure semiconductor

In areas where walls are frequently washed conduit should be mounted with __ inches of air space between the wall and the conduit

___ locations are those that are hazardous because of the presence of easily ignitable fibers or flyings

Which of the following is standard size fuse?

An electrical time switch for lighting is normally connected in ___ with the lighting circuit being controlled

The definition of ambient temperature is ____

The resistance in a circuit may be increased by ___

The maximum current a #12 THW copper conductor connected to a 20 amp circuit breaker would ever carry under any condition could be ___ amperes.

How many #12 XHHW conductors can you install in a 3/8” flexible metal conduit with the use of inside fittings?

At what angle does a header attach to a floor duct?

When more than one calculated or tabulated ampacity could apply for a given circuit length, the __ value shall be used.

an electrical timer switch for lighting is normally connected in ___ with the lighting circuit being controlled

The voltage per turn of the primary of a transformer is __ the voltage per turn of the secondary

The temperature of the shunt field motor increases from 20°C to 30°C after 3 hours of operation. This increase in temperature produces what effect on the behavior of the motor?

Automatic device that operates at present values is known as ___.

The minimum wire bending space within the enclosure for motor controllers for a 1/0 conductor (2 wires per terminal) would be __ mm

Bussways rated over 600 volts shall have all conductor termination and connection hardware accessible for __. I. Maintenance II. Connection III. Installation

Conductors which supply one or more AC transformers or DC rectifiers are welders shall be protected by an overcurrent decide rate or set at not more than ___ percent of the conductor rating

Which resistor is physically larger in size?

An open coil can be detected by ___ reading

The ___ shall be executive officer of the board (BEE)