問題一覧
1
Operating a forklift with a load raised in a straight line or turning is dangerous, why?
Height reduce stability
2
What three penalties can the Workplace Health&Safety(WHS) regulator aapply if you fail to work safely when doing High Risk Work?
Licence suspended, Licence cancelled, Refusal to renew licence
3
When using the forklift why is "rear end" swing dangerous? Rapid sideways movement:
Can cause injury or damage
4
Raising or lowering a load near or over people is not allowed, why?
risk of Injury or death
5
To maintain stability of the forklift and the load, a side-shift attachment should always be
Centred before moving a load
6
Where would you look to find the forkloft and attachment rated capacity?
Data Plate
7
If the load is not fully against the heel of the fork arm, how will this affect the operation of the forklift?
Stability and capacity is reduced
8
How do you find out the voltage of overhead electric power lines?
Check with local electrical authority
9
What are six actuons that may cause a forklift truck to tip over sideways
Unsafe speed and turning, Uneven surfaces, Uneven load, Flat tyre, Driving too fast, Turning with load to high, Side shift not centred, Turning on a slope
10
Keeping air filled tyres at correct operating pressure is important, why us this so?
Maintain stability and safety of forklift
11
When can passengers ride on a forklift?
Only if it has a multi-person seat
12
The point of balance (fulcrum) is where on a forklift?
Centre of front wheels at tyre pivot
13
Post Start Up Checks - List six checks you conduct after your seat belt is on and the engine is started
Gauges, Lights, Horn, Reverse Beeper, Steering, Brakes
14
Before commencing work, what are eight things you need to consider and plan for OTHER THAN PREVIOUSLY STATED SITE HAZARDS when planning the task?
Permits, Location, Access, Communication, Egress, Skills, PPE, Licences
15
Internal combustion engines (petrol,gas,and diesel) produce dangerous gases (carbon monoxide). why don't we use them in restricted spaces? ㅡㅡㅡㅡㅡㅡㅡㅡㅡ/ What type of forklift do you use in restricted spaces with minimal airflow?
Fumes could kill, Electric
16
On conducting a pre-start check you fine the data plate is missing or unreadable, what should you do
Stop, Tag, Report
17
When moving a forklift with or without a load, what is a 'safe' height to carry the load at?
At axel height or as low as possible
18
What are four ways you can communicate with other workers on site?
Verbal, Written, Signs, Hand Signals
19
List THE FIVE steps you should take if the forklift you are operating comes in contact with electric power lines.
WARN others to stay clear, BREAK contact with lines, STAY in the machine if it's safe. if you must leave the machine (fire) jump clear without touching the forklift and shuffle up to 8 meters away, REPORT to an authorised person, CHECK before re-using
20
List twelve site hazards you need to consider and plan for in the workplace before starting forklift operations.
Power lines, Trees, Overhead services, Awnings, Roller doors, Bridges, Buildings, Vehicles, Plant & equipment, Pedestraians, Ground conditions, poor lighting
21
Having just completed a course and obtained you HRW forklift licence, List four things your employer must provide to you before operating unfamiliar equipment
Supervision, Information, Instruction, Training
22
What effects does a jib attachment have on a forklift? Give three effects.
Reduced Load capacity, Increase COG, Swinging load, Reduced stability
23
List five visual indicators used to identify power lines
Tiger Tails, Marker Balls, Warning/Danger Signs, Coloured markers, Painted power poles
24
Why should the load movement be watched when moving the forklift?
Stability of load and safety to people
25
When leaving the forklift why should you remove the ignition key?
Prevent unauthorised use
26
When operating a forklift on a wet or slippery surface, what are two ways you can operate safely and stay safe?
Reduce Speed, No hard breaking
27
why is it unsafe to refuel while the engine is running?
Fuel could ignite and cause a fire
28
List three people you would discuss with about workplace hazards before you start work and explain why.List three people you would discuss with about workplace hazards before you start work and explain why.
Other workers, Supervisor, Safety Officer, Policies and Procedures
29
Indicate the load Centre Distance on the forklift pictured
COG LCD FULCRUM
30
Pre-Operational Checks(walk around) are required to be carried out on a forklift truck before getting on to operate, list nine
No visible Damage, Forks and attachments, Under machine for oil leaks, Mast, Hydraulic rams, Hoses, Data plate, Oils, Battery
31
List five checks you should do on tyres and wheels on a forklift. DEFECTS
Air pressure is Not correct, Tyres Not below wear indicator, Tyres NOT securely fitted to rims, No chunks missing from the rubber tyres, Tyre wear is even Uneven
32
If a co-worker gives you a signal which is not clear to you, what should you do?
Stop and communicate
33
Explain what a hazard is
A danger that can cause harm
34
List three things that an employer must do to ensure the health and safety of all employees
Provide safe plant and equipment, Provide safe systems of work, Provide adequate facilities
35
if you view is obstructed while driving the forklift, what are four things you could do before you move?
Check pathway is clear, Travel in reverse, Use a spotter, Restack Load
36
What do you have to do if your HRW licence has not be renewed within 12 months of its expiry?
Retrain and sit an assessment with a RTO as you cannot renew
37
How would you find out the correct way of fitting any attachment to a forklift?
Manufacturer is instructions
38
When carrying out HRW as an employee / worker , you have a legislated Duty of Care. List four responsibilities that this implies
Make sure of your own health, Don't put others in danger, keep yourself safe, Comply with relevant WHS regulations
39
Why is it unsafe to turn a forklift on a ramp or sloping surface? Provide two reasons
Could make the forklift tip, losing the load
40
Explain what a risk is
The chance of a hazard causing harm or damage
41
What important role does the seatbelt perform on a forklift?
It will stop falling out
42
List four ways the weight of a load can found out?
Consignment note or docket, Weighing the load with scales, Calculate weight, Load markings
43
What is the name of the steel structure supplied for the gap between a truck and a loading dock? These MUST be secured.
Dock plates or Bridge plates
44
Carrying a load on only one fork arm is unsafe. Why is this so?
Stability reduced, Damage the forklift, Lose the load
45
What could the effects on a forklift be after adding any attachment? Give 2.
Reduced forklift capacity (Capacity of the forklift will be reduced), LCD may increase
46
List six actions that might cause a forklift truck to tip over frontwards or backwards when moving
Overloaded, Hard braking, Mast tilted forward, Driving too fast, Forward down a slope, Uneven surfaces
47
List four weather-related hazards that can impact forklift operations
Heat, Smoke, Snow and Ice, Slippery
48
When charging batteries, why should they be charged in well-ventilated areas?
Dangerous gases and could explode
49
What is the most common load centre on forklifts in Australia?
600mm
50
What are the minimum safe distances you must maintain when working on a forklift near power lines in QLD?
3m, 6m, 8m
51
List five attachments that can be used on a forklift... other than fork tynes
Carpet spike , Jib, Work Platfrom, Fork extensions, Drum Clamp
52
What is the 'normal' parking procedure of a forklift?
Lower fork arms to the ground, Park brake applied, Select neutral, Remove key
53
Where is it unsafe to park a forklift in a workplace. Provide seven areas
Doorways, Fire fighting equipment, On sloping surface, First aid stations, Walkways, Emergency exits, Railway crossings
54
If you need to move a load up or down a ramp, what direction must the load face?
Uphill
55
List four things you would do if the forklift you are operating breaks down in any way
Stop Operating, Lower forks to ground, Tag Out, Report and repair before re-using
56
What equipment is required to operate a forklift in dark areas or at night?
Adequate lighting
57
List four workplace safety information documents that you can obtain
Code of practice, Australian Standards, Regulations, Legislation
58
What do you look for when stacking loads on top of each other?
Firm Level Surface, Heavy or Liquid goods on bottom, High loads unstable
59
List six safety control measures that can be used to protect pedestrians, other workers, vehicles or mobile plant.
Stop / Go person, Hazard lights, Signs, Barriers, Exclusion zones, Traffic management plan
60
If the forklift starts to roll over sideways, what two things should you do?
Stay in the forklift, Brace until stopped
61
What is meant by LCD?
distance from heel to centre of gravity
62
List three guards fitted to a forklift, and what do they protect.
Overhead guard - Protects the operator from falling objects, Foot guard - Protects the feet, Load guard - Stops the load from hitting the mast and protects the operator
63
How can finding out weather forecasts help to plan tasks, especially in relation to outside work? (give 3 reasons)
Prepare for suitable risk controls, Plan the work environment, Schedule work activities