M7c8

8問 • 2ヶ月前

ユーザ名非公開

通報

問題一覧

……..should not subjected to large tensile load

Rivets are designed to be strong in shear and less so in tension therefore

Using a bucking bar which is too light means that the gun

must deliver more blows and may result in premature hardening of the rivet or damage to the skin surface.

When removing a cherryLOCK or cherryMAX rivet,

you should first use a drill the same diameter as the pin, and remove the pin by drilling enough to remove the locking ring, then pinching out the pin with a pin punch.

when using a dipper to gauge the length of a cherry rivet to be used on a riveted joint, the gauge indicates just above (-4).

The length of rivet you should use is 5/16 inch.

the distance between the rivet centre and the edge of the material 2D minimum

Land

Used in places where stress is not particularly high and where flush surfaces are not required often used in longitudinal aircraft skin joints

lap joint

The minimum space between rivets is determined by

the diameter of the rivets being used

The tool is used to cut rivets to size prior to driving

Rivet cutter.

module 1 ch1

ユーザ名非公開 · 53問 · 11ヶ月前

module 1 ch1

53問 • 11ヶ月前

ユーザ名非公開

ユーザ名非公開 · 68問 · 11ヶ月前

68問 • 11ヶ月前

ユーザ名非公開

ユーザ名非公開 · 68問 · 11ヶ月前

m4 ch 2

m4 ch 2

m4 ch 3

m4 ch 3

m 4 ch 4

m 4 ch 4

M15c1

M15c1

M15c2

M15c2

M15c3

M15c3

M15c4

M15c4

M15c3

M15c3

M15c4

M15c4

M15c5

M15c5

M15c6

M15c6

M7c1

M7c1

M7c2

M7c2

M7c3

M7c3

M7c3

M7c3

M7c4

M7c4

問題一覧

……..should not subjected to large tensile load

Rivets are designed to be strong in shear and less so in tension therefore

Using a bucking bar which is too light means that the gun

must deliver more blows and may result in premature hardening of the rivet or damage to the skin surface.

When removing a cherryLOCK or cherryMAX rivet,

you should first use a drill the same diameter as the pin, and remove the pin by drilling enough to remove the locking ring, then pinching out the pin with a pin punch.

when using a dipper to gauge the length of a cherry rivet to be used on a riveted joint, the gauge indicates just above (-4).

The length of rivet you should use is 5/16 inch.

the distance between the rivet centre and the edge of the material 2D minimum

Land

Used in places where stress is not particularly high and where flush surfaces are not required often used in longitudinal aircraft skin joints

lap joint

The minimum space between rivets is determined by

the diameter of the rivets being used

The tool is used to cut rivets to size prior to driving

Rivet cutter.