問題一覧
1
Can you mark a live line tool to ensure that you do not work too close to the end?
yes, provided it does not damage the integrity of the stick.
2
What is the hotline tool picture?
insulator fork
3
Name four things to look for during a live line tool inspection deep cuts
deep cuts
4
What is the tool pictured?
rotary blade
5
What is the tool pictured?
lever lift
6
Rubber gloves must be _____ either before climbing the pole or before entering the danger zone and _____ until outside the danger zone or back on the ground.
put on, not removed
7
On an aluminum hand applied top tie, what is the appropriate sequence of buttons on each side of the insulator?
one, three, two
8
Safety belts will be fastened to the safety board (Baker board) staging, or protective equipment shall be placed around the pole and the safety belt shall be placed around the pole over the protective equipment.
true
9
A(an) _____ is placed on the cross arm and is used to hold the hot sticks while they are not in use.
arm caddy
10
The maximum load to any hotline tool will support without the danger of breaking depends on the _____ of the tool on the structure and its _____ to the other tools you can conjunction with it.
position, relation
11
When liveline tools are in use, what other work can be done on the pole?
no other work may be performed.
12
The use of wooden live line tools (hot sticks) is permissible.
false
13
Except for emergency work, live line tool work shall not be done in the rain, snow, mist, high winds, or inclement weather.
true
14
When untying a hand tie wire from an energized conductor using the hot stick method, what precaution should be taken and why?
the wire tie should be kept short as it is untied to prevent the possibility of it making contact with anything other than the conductor, hot stick, or insulator.
15
Live line tools shall be _____ and _____ before each day.
wiped clean, visually inspected
16
What is the tool picture?
armor rod applicator/ring stick
17
What's the tool pictured?
pole saddle or wire tong saddle
18
What is the tool pictured?
Cotter key puller and installer
19
Weight loading _____ considerably on hilltop structures dependent on the _____ of the line grade.
increases, steepness
20
Which of the following attachments are commonly used to install or remove preformed ties and armor rod with a hot stick?
a hot rodder or ring stick attachment
21
According to 301.05 of the manual of safe practices where are you required to use approved hotline tools? Explain your answer.
I'm not answering this, look at the picture.
22
Exposed conductive articles and other unnecessary metallic accessories will not be worn while working on or near energized equipment.
true
23
What are the three major requirements that must be met by the manufacturer of high quality hotline tools?
insulating qualities, strength, light in weight
24
While engaging in hot stick work, rubber type or fiber protective equipment must be applied with live line tools when circuits are in condition B and condition c.
true
25
What is the tool pictured?
rotary prong
26
Chance universal hot stick tools are made from what material?
epoxy glass with a plastic foam core
27
What is the tool picture used for?
hold conductors in the clear of work being done
28
When moving a conductor you must always have a minimum of _____ points of attachment.
two
29
What is the minimum distance your hand can come from the energized end of a live line tool while hot sticking 15 kV?
3 ft
30
What is the tool pictured?
wire tong band