Is a passive two-terminal electrical component which exhibit solely a resistance

It is used to model the current-resisting behavior of a material

Resistor can either be _ or _

Are those whose resistance does not change with the change in voltage or temperature

Are those which the electric resistance value can be adjusted

Are used when there is a need to dissipate a large amount of heat

Are used when large resistance is needed

Wire wound and composition resistor are?

Is a three terminal resistor with a sliding or rotating contact that forms an adjustable voltage divider

Is used to control current

States that the ratio of potential difference between any two points on a conductor to the current flowing between them, is constant, provided the temperature of the conductor does not change

The value of resistance is zero when the circuit is

In _ no voltage can exist across it and current through it is very large

The value of resistance is infinite when the circuit is

In _ there is no flow of current and resistance between two points is infinite

Is a circuit whose parameters are constant

Is a circuit whose parameters change with voltage or current

Is a circuit whose properties or characteristics are the same in either direction

Is a circuit whose properties or characteristics change with the direction of its operation

Is a network that contains no source of electromotive force

Is a network that contains one or more than one source of electromotive force

Is the properties relating to the placement of elements in the network and the geometric configuration of the network

Is a part of a network which lies between two junction or nodes

Is a point or junction where two or more circuit elements are connected together

Is a close path in a circuit in which no element or node is encountered more than once

Is a loop that contains no other loop within it

States that the algebraic sum of the voltages around a closed circuit path must be zero

States that the algebraic sum of all currents entering and exiting a node or junction must be zero

In the _ elements share a single node and carry the same current but voltage is dropped across each of the resistances

Resistances are additive in?

In series circuit, powers are?

In the _ elements are connected to the same two nodes and have the same voltage across them.

Branch circuit are additive in

Conductances are additive in

Powers are additive in

It is a solution that employs a system of loop or mesh currents instead of branch currents

It forms when two meshes have a common current source

In applying ohm’s law, the current _ and voltage _ is important