M7c5

11問 • 2ヶ月前

ユーザ名非公開

通報

問題一覧

In first angle projection each view shows what would be seen

by looking on the far side of an adjacent view (opposite upper).

When a large area is shown sectioned the hatching may be limited to

that part of the area which touches adjacent hatched parts or the outline of the large part

The symbol (M) in detail (f) of Figure 5.13, indicates

that the tolerance applies only to the maximum material condition of the dimension or datum feature and may be greater at the actual finished size.

Since 1 June 1956, the Air Transport Association of America (ATA), has used a specification, to:

establish a standard for the presentation of technical data provided by aircraft, engine or component manufacturers.

A limit system is on a shaft basis when the shaft is the constant member and the different fits are obtained by varying the size of the hole

shaft basis

A limit system is on a hole basis when the hole is the constant member and different fits are obtained by varying the size of the shaft

Hole basis

A schematic diagram show

the functional location of components within a system.

If a design amendment is made on a drawing

a new issue number and date must be allocated to the drawing.

Drawing numbers are

unique to each drawing.

Hatching lines are usually drawn at :

60°

An Oblique view is shown face on with the sides and plan projected at an angle of :

45º - 60º.

module 1 ch1

ユーザ名非公開 · 53問 · 11ヶ月前

module 1 ch1

53問 • 11ヶ月前

ユーザ名非公開

ユーザ名非公開 · 68問 · 11ヶ月前

68問 • 11ヶ月前

ユーザ名非公開

ユーザ名非公開 · 68問 · 11ヶ月前

m4 ch 2

m4 ch 2

m4 ch 3

m4 ch 3

m 4 ch 4

m 4 ch 4

M15c1

M15c1

M15c2

M15c2

M15c3

M15c3

M15c4

M15c4

M15c3

M15c3

M15c4

M15c4

M15c5

M15c5

M15c6

M15c6

M7c1

M7c1

M7c2

M7c2

M7c3

M7c3

M7c3

M7c3

M7c4

M7c4

問題一覧

In first angle projection each view shows what would be seen

by looking on the far side of an adjacent view (opposite upper).

When a large area is shown sectioned the hatching may be limited to

that part of the area which touches adjacent hatched parts or the outline of the large part

The symbol (M) in detail (f) of Figure 5.13, indicates

that the tolerance applies only to the maximum material condition of the dimension or datum feature and may be greater at the actual finished size.

Since 1 June 1956, the Air Transport Association of America (ATA), has used a specification, to:

establish a standard for the presentation of technical data provided by aircraft, engine or component manufacturers.

A limit system is on a shaft basis when the shaft is the constant member and the different fits are obtained by varying the size of the hole

shaft basis

A limit system is on a hole basis when the hole is the constant member and different fits are obtained by varying the size of the shaft

Hole basis

A schematic diagram show

the functional location of components within a system.

If a design amendment is made on a drawing

a new issue number and date must be allocated to the drawing.

Drawing numbers are

unique to each drawing.

Hatching lines are usually drawn at :

60°

An Oblique view is shown face on with the sides and plan projected at an angle of :

45º - 60º.